johnino
Member

471 Likes

Page 5 of 32 First 12345678910111213141516171819 ... Last

• Jump to page:

1. 
   johnino liked post by Sean On thread : What little pesties did you bowl over today?

   Got another hare today. Very happy with my new .22 https://youtu.be/2N4Lq1nmmyM

   Liked On: 28-10-2016, 12:20 PM

2. 
   johnino liked post by distant stalker On thread : Photos your proud of -not just hunting

   57186

   Liked On: 28-10-2016, 11:01 AM

3. 
   johnino liked post by StrikerNZ On thread : Photos your proud of -not just hunting

   This fat wee pudding was making a racket in the front garden this morning, so seemed only right to pull the camera out. Very happy with this shot. 58111

   Liked On: 28-10-2016, 11:01 AM

4. 
   johnino liked post by sneeze On thread : Trail camera pics

   41079

   Liked On: 09-10-2015, 07:35 AM

5. 
   johnino liked post by Scouser On thread : refill your disposable canisters

   Fuk, they must have sold out of the 'good ones' and had to make a quick batch of plastic tikka ones......:ORLY:

   Liked On: 06-10-2015, 11:07 AM

6. 
   johnino liked post by specweapon On thread : refill your disposable canisters

   Sorted it by slicing the rubber seal that came on it in half and using the front tapered half, still can't figure out why the fitting was locking into the cylinder fine and engaging the gas valve but...

   Liked On: 03-10-2015, 01:08 PM

7. 
   johnino liked post by veitnamcam On thread : refill your disposable canisters

   Thats the problem,you always think that might run out better take a new one....and end up with a shitload of half emptys. unless that is you can refill them:thumbsup:

   Liked On: 19-09-2015, 09:48 AM

8. 
   johnino liked post by homebrew.357 On thread : Making a Sharps Barrel in my lathe.

   Hi all, The receiver has a radius on the top, sides of the b/block, so with my normal ingenuity ;) I set it up on the lathe and using my electric drill clamped to the angle bracket with a grinding...

   Liked On: 17-09-2015, 01:22 PM

9. 
   johnino liked post by Dundee On thread : Dinner thread?

   Slow cooked lamb in the crock pot for dinner tonight.:D Should be ready after work. 40432

   Liked On: 09-09-2015, 01:17 PM

10. 
    johnino liked post by veitnamcam On thread : refill your disposable canisters

    Often see 2 or 3 or even 4 all but empty cans left in a hut... Nobody wants your empty gas cans. Carry them out ya lazy cunts you are not doing anyone a favor. Sent from my SM-G800Y using...

    Liked On: 08-09-2015, 02:16 PM

11. 
    johnino liked post by zeropak On thread : ZeroPak Vacuum Film Deals

    Hi, Yes they may be slightly cheaper. We can also source cheaper film, we went down that track in the early days, it gave us nothing but grief. When we buy film we look for the very best and then we...

    Liked On: 04-09-2015, 10:18 AM

12. 
    johnino liked post by stretch On thread : Dinner thread?

    Making this again. Managed to fit all four limbs off a young Kid (no, not the pet one that got smoked by a car last week) into the slow cooker this time. Best goat curry recipe I've found so far....

    Liked On: 03-09-2015, 10:05 PM

13. 
    johnino liked post by zeropak On thread : ZeroPak Vacuum Film Deals

    Hi There, As requested here are some deals on Vacuum Film. These are one off deals and are limited so get in Quick. 5 x 12m packs of 20cm wide roll film for $100 4 x 12m packs of 28cm wide...

    Liked On: 02-09-2015, 03:10 PM

14. 
    johnino liked post by zeropak On thread : Vacume packed meat

    Ok Guys, It has taken a little while to get this all set up. Anyway, ask and you will receive. I have set up a couple of bulk buy deals for you on Vacuum Film these are deals that are available no...

    Liked On: 02-09-2015, 02:06 PM

15. 
    johnino liked post by Pengy On thread : Dinner thread?

    I just polished off my first ever roast Goat leg, shot at the recent Puhoi gathering. 3 and a half hours at aprox 120 degs, served with the usual trimmings of tats and parsnips. It was pretty damn...

    Liked On: 01-09-2015, 11:04 PM

Page 5 of 32 First 12345678910111213141516171819 ... Last

• Jump to page: