Longrun
Member

411 Likes

Page 6 of 28 First 1234567891011121314151617181920 ... Last

• Jump to page:

1. 
   Longrun liked post by veitnamcam On thread : Tight cases after putting through the die

   I have had this with a die/rifle combination before. As the die squeezes in the sides of the body and shoulder the shoulder is pushed forwards a thou or two and kissing the shell holder wouldn't...

   Liked On: 19-10-2024, 06:42 PM

2. 
   Longrun liked post by Oldbloke On thread : Tight cases after putting through the die

   Strange things happen if you don't occasionally anneal. also lightly lube the inside of the neck as well as outside for all sizing.

   Liked On: 19-10-2024, 06:41 PM

3. 
   Longrun liked post by Dan88 On thread : One step closer to reloading

   Yea you could almost operate in a workshop that clean! I can't even see my bench!

   Liked On: 19-10-2024, 04:34 PM

4. 
   Longrun liked post by nevereadyfreddy On thread : One step closer to reloading

   The first view is not cluttered,trust me

   Liked On: 19-10-2024, 04:33 PM

5. 
   Longrun liked post by Tahr On thread : A superb article on why "node load deveopment" is toast

   Ive mucked around with neck sizing but for hunting the security of knowing every round will fit the chamber is reassuring. My load development has always been random and unsophisticated. Work...

   Liked On: 17-10-2024, 09:40 AM

6. 
   Longrun liked post by Dicko On thread : .270 is the best caliber ever made.

   But it’s long enough. But to get the most out of it you want the long action. Just can’t understand the phobia on carrying a long action. Sent from my iPhone using Tapatalk

   Liked On: 13-10-2024, 09:20 AM

7. 
   Longrun liked post by blip On thread : The x55 and barrel length

   Ok seems around 20" is a good compromise Ill get the gunsmith to do a measure and see if there's enough to do my preferred thread

   Liked On: 12-10-2024, 05:15 PM

8. 
   Longrun liked post by Micky Duck On thread : Crackdown in Wairarapa

   Run tractor and post rammer down and poke six posts in tight against car then go back to bed. One at each end and one close to each door so can't get into vechille. They can't go home.

   Liked On: 09-10-2024, 07:22 AM

9. 
   Longrun liked post by Yesmate On thread : Crackdown in Wairarapa

   you should have completely disabled their vehicle via damage.that would have more punch than the cops.

   Liked On: 09-10-2024, 07:22 AM

10. 
    Longrun liked post by brad On thread : Crackdown in Wairarapa

    The problem is that the police don't care about rural crime. We pay the same amount of tax as everyone else, but we are the first to be overlooked. I had two poachers on camera at 2.30 am. I rang...

    Liked On: 09-10-2024, 07:17 AM

11. 
    Longrun liked post by whanahuia On thread : Crackdown in Wairarapa

    As long as they follow through. Im dubious, as to be really serious will take alot of manpower and time, and historically this has been low priority. Case in point. Tom Phillips is spotted and they...

    Liked On: 09-10-2024, 07:14 AM

12. 
    Longrun liked post by Husky1600#2 On thread : Reloading new-bie - 7x57 OAL question

    I wouldnt get too concerned with it, the 7x57 can be very forgiving and most rifles chambered in 7x57 have long throats. Seat the projectile so the base of the projectile stops about the base of the...

    Liked On: 08-10-2024, 07:12 AM

13. 
    Longrun liked post by Njappers On thread : Reloading new-bie - 7x57 OAL question

    I believe the 7x57 was designed for those long roundnose 175gr bullets. My Brno model 21 lands is way out there. I load 174gr PPUs to a total length of 80mm with comfortable amount of bullet on the...

    Liked On: 07-10-2024, 01:07 PM

14. 
    Longrun liked post by Roarless20 On thread : Reloading new-bie - 7x57 OAL question

    Sounds like the chamber has a long throat for those projectiles. Just seat them 6-7mm into the case neck.

    Liked On: 07-10-2024, 01:06 PM

15. 
    Longrun liked post by csmiffy On thread : Necessity is mother of invention.

    Knock the primer out of an empty case works well too

    Liked On: 01-10-2024, 08:30 PM

Page 6 of 28 First 1234567891011121314151617181920 ... Last

• Jump to page: