m101a1
Member

388 Likes

Page 15 of 26 First 1234567891011121314151617181920212223242526 Last

• Jump to page:

1. 
   m101a1 liked post by kotuku On thread : Some thoughts on gear companies.

   i use a lot of ex military gear for my hunting etc .why -well theres an old saying if a soldier or toddler cant bugger it ,it must be fit for purpose! I also wear ridgeline -why because it suits me...

   Liked On: 19-02-2023, 05:40 PM

2. 
   m101a1 liked post by mikee On thread : Firearms ban in Western aussie

   The reason we will lose our hobby in the end is Apathy, that and the fact that most user cannot seem to understand that throwing each under under the bus in the vain and forlorn hope that they will...

   Liked On: 17-02-2023, 01:17 PM

3. 
   m101a1 liked post by hamish9701 On thread : Class 1 DG house insurance

   A lot of them have door seals that only expand when exposed to heat so probably not water tight. That and the bolt holes in the floor.

   Liked On: 16-02-2023, 03:46 PM

4. 
   m101a1 liked post by Billbob On thread : Finally got a thermette

   I understand that after WW2 the Germans wanted to know how the NZ and Aussie troops could sit down have a brew then carry on fighting so quickly. They always knew where our soldiers had been by the...

   Liked On: 12-02-2023, 08:41 PM

5. 
   m101a1 liked post by yerimaginaryM8 On thread : 15ft fiberglass boats. Education required

   If it were me I would be reluctant to buy an older glass hull. Up until the 90's the transoms in most glass boats contained significant amounts of wood and the stringers in the hull were also wooden....

   Liked On: 12-02-2023, 12:15 PM

6. 
   m101a1 liked post by Got-ya On thread : Show us your boat

   My new toy as I picked it up last weekend. 645 Aqualite with 2018 150 Yamaha, 60hrs on the clock. Taken a while and lots of patience to find this. Not many come up and the ones that have, all had...

   Liked On: 09-02-2023, 09:48 PM

7. 
   m101a1 liked post by tac a1 On thread : New electronics?

   there's nothing wrong with a FVC295. Thats what I'm running in my boat. It's the transducers which make the difference. The transducers in my boat (there's two of them) are a 200 khz unit and a...

   Liked On: 08-02-2023, 08:26 PM

8. 
   m101a1 liked post by gonetropo On thread : Seal Attack !

   if a male sealion is chasing you throw some tupperware at them...............they will stop chasing you because they like a good tight seal

   Liked On: 05-02-2023, 10:55 AM

9. 
   m101a1 liked post by Ryan_Songhurst On thread : 2stroke outboard

   Modern E-tec outboards actually blow the four strokes away for clean running and low exhaust emissions. Some of the first ones got a bad rap for reliability but a mate has a 200 E-tec on a big hard...

   Liked On: 26-01-2023, 10:35 PM

10. 
    m101a1 liked post by Barry the hunter On thread : Kahawai

    ya good man Chur Bay -hate to see people wasting fish - I like Kahawai - bleed - marinate in lemon juice good 4-6 hours - mix in some coconut cream freshly chopped spring onion bloody delicious

    Liked On: 24-01-2023, 09:58 PM

11. 
    m101a1 liked post by Bill999 On thread : Seeking300 Blackout Howa 1500 Mini Action Rifle Experts

    if you zero subsonics at 30m you will find that the 135gr supersonic will be zeroed roughly for 140m

    Liked On: 24-01-2023, 09:54 PM

12. 
    m101a1 liked post by 300_BLK On thread : Seeking300 Blackout Howa 1500 Mini Action Rifle Experts

    Hey Quintin, I have had a 300BLK for a long time and shot most animals in nz with it with the exception of Thar and wild cattle. 1 - I'd use the 110gr vmax if reloading over a charge of either...

    Liked On: 23-01-2023, 08:29 PM

13. 
    m101a1 liked post by hunter Al.7mm08 On thread : Akkar extractor replacement

    Quick update for anyone interested. Couldn't get hold of the pin with side cutters, just no room. Tried driving the pin out from the back as gundoc suggested. Ended up bending the...

    Liked On: 17-01-2023, 06:20 PM

14. 
    m101a1 liked post by caberslash On thread : Calculating front sight height ? ( maths heavy )

    Stuff the formulas, solution is to put a big zip tie on the barrel with the end being vertical. Use it as a front post and keep cutting it till you get the right height. Good luck.

    Liked On: 16-01-2023, 11:35 AM

15. 
    m101a1 liked post by Jhon On thread : Redundant Calibres

    I have a 1905 Winchester single shot .22 "Boy's Rifle". At least that's how I think of it. A lovely proportionate small 22. Bought it in Dunedin in 1980 for $25. It was well worn when I got it with a...

    Liked On: 12-01-2023, 10:31 PM

Page 15 of 26 First 1234567891011121314151617181920212223242526 Last

• Jump to page: