Look into your mount, get some advice from someone that shots alot of clays and find one that fits. Dont listen to the salesman he normally doesnt give a shit just wants to sell you $3600 A400. I...
Liked On: 13-02-2022, 11:32 AM
One of the triggers I cut my teeth on when I started professional gunsmithing more than 50 years ago was the 3-lever BSA trigger as found on the Royal, Viscount, Hunter, and early Majestic rifles,...
Liked On: 11-02-2022, 08:48 PM
Speedy recovery Antsman.Iv seen a few bad accidents on building sites in the 50yrs in the trade.Id say you got away from a very serius accident by the taste of that ice cream lols.The next battle is...
Liked On: 09-02-2022, 09:21 PM
yeah mate- i hope i dont see any more of these :)
Liked On: 09-02-2022, 09:21 PM
Thanks for the feedback, my Haines has a near new 90 hp merc 2 stroke, done less than 10 hours, it’s a good boat but just musing about something different. I was thinking either a 3.6 or a 4.2, but...
Liked On: 08-02-2022, 09:19 AM
They used to use the 570 Macs in Rarotonga as dive boats. All of them got retired due to splits in the hulls I believe. All that flexing had to come with a downside. This might not be an issue in a...
Liked On: 08-02-2022, 09:19 AM
189212 189213
Liked On: 01-02-2022, 06:03 PM
Yep, stop just neck sizing. FL them everytime, its the only way you can keep case dimensions consistent each and every time. If that case has been fired in a different chamber that will be the...
Liked On: 31-01-2022, 11:43 AM
In my experience, club members are eager to show visitors what it's all about and pretty much everyone will get you to have a go with their pistol. I wouldn't make any decisions on brand/style before...
Liked On: 12-01-2022, 09:18 PM
Last time I had flounder was on the Chatham Best I've ever had I know But try it Fillet Floured With salt and pepper Lightly fried
Liked On: 07-01-2022, 09:06 PM
And bubba Weatherby uses Rustoleum rattle cans at $12 a pop, epoxy solvent to clean, followed up by a clean with meths, spray light coat and hang in a sunny corner, repeat the next day and leave for...
Liked On: 02-01-2022, 09:54 PM
Go Jap, 100%. Get a nice little dual propose 250. Not to heavy but lets you ride on the open road to further spots and enough power not to get buried by traffic round town.
Liked On: 21-12-2021, 09:06 PM
The easy way to put dovetails in is with a hacksaw, a 3-suqare file with one surface ground dead, and a good flat file. Put two hacksaw slots to the correct depth spaced just inside the narrow part...
Liked On: 17-12-2021, 02:30 PM
One of the comments on that video has great advice in it as well. Pretty much what I’ve been trying to do, but it is painfully slow and mentally tiring. Results have been good so far though, been...
Liked On: 02-12-2021, 02:51 PM
I have 44 mag, 30-30 and 308 levers and for your described top of gully situation I would reach for the 308. More legs, more punch and easy to down load to 30-30 levels if you want. Mount a 2-7x 32...
Liked On: 14-11-2021, 10:16 PM