Magnetite
Member

104 Likes

Page 7 of 7 First 1234567

• Jump to page:

1. 
   Magnetite liked post by Bagheera On thread : Matches with hunting bullets

   For me, there's a definite benefit to using just one bullet and getting to know it. I use a hunting bullet with excellent terminal ballistics and good accuracy(NBT) and shoot about half of them at...

   Liked On: 29-06-2021, 09:22 PM

2. 
   Magnetite liked post by Pommy On thread : Matches with hunting bullets

   I used to do that but have kind of stopped and tend to do a bit more research on the specific bullets I'm considering. Manufacturers know that BC sells, so there's been a bit of a push towards...

   Liked On: 29-06-2021, 07:55 PM

3. 
   Magnetite liked post by grandpamac On thread : Soot On Case Bodies

   Greetings Again, The powder all burns in the barrel in spite of what some believe so the problem with AR2213SC is you can't get enough in the case to develop the velocity. Hodgdon gives a load of...

   Liked On: 12-04-2021, 04:08 PM

4. 
   Magnetite liked post by gundoc On thread : Soot On Case Bodies

   It looks like you are using a suppressor in which case the sooting is a normal by-product caused by a higher residual bore pressure after the shot has left the barrel and is nothing to be concerned...

   Liked On: 12-04-2021, 11:08 AM

5. 
   Magnetite liked post by Pommy On thread : New to reloading - to what fraction of a grain do you test new loads? 0.5gr, 0.3gr...

   1% of case capacity, rounded to the nearest .1 is a decent guideline.

   Liked On: 20-01-2021, 05:36 AM

6. 
   Magnetite liked post by Marty Henry On thread : Split shoulders

   Ook please pass me that banana

   Liked On: 09-11-2020, 05:39 PM

7. 
   Magnetite liked post by rupert On thread : Split shoulders

   The brass is corroded and/or brittle with age. Some old brass is perfectly usable after annealing to deal with the brittleness of age. Some old brass is corroded due to bad storage so much so that it...

   Liked On: 04-11-2020, 08:25 PM

8. 
   Magnetite liked post by grandpamac On thread : Notes for New and Newish Hand Loaders from an Old Fudd

   Greetings All, Post 8 Simple Ways of Setting Cartridge Overall Length and Annealing Cases. There are both high tech and low tech ways of carrying out our hand loading. These are usually matched...

   Liked On: 10-10-2020, 09:24 PM

9. 
   Magnetite liked post by ebf On thread : Primer testing methods

   Couple years back Winchester primers had some quality control issues. Lot of people ended up with gas cut bolt faces. Use them at your peril.

   Liked On: 11-09-2020, 01:50 PM

10. 
    Magnetite liked post by Flyblown On thread : 6.5mm sub 250m bullet recommendations

    Do a google search for Speer Gold Dot expansion tests. Jonny tested the 6.5 them quite thoroughly. I don’t really see the point of doing an expansion test at 10 yards though... ...

    Liked On: 06-09-2020, 05:47 PM

11. 
    Magnetite liked post by Pommy On thread : 6.5mm sub 250m bullet recommendations

    Basically one or two votes for each bullet out of the entire catalogue. Hope we managed to narrow it down for you :thumbsup:

    Liked On: 05-09-2020, 01:03 PM

12. 
    Magnetite liked post by grandpamac On thread : Preferred barrel bullet weight

    Greetings All, I think that there is one thing that we have glossed over. Our first step should be to decide what we are trying to achieve. If our load is primarily for long range shooting or is it...

    Liked On: 03-09-2020, 11:08 AM

13. 
    Magnetite liked post by grandpamac On thread : 6.5x55 SE Sanity Check

    Greetings Magnetite, I tried 49 and 50 grains of AR2213SC behind the 129 grain SST which gave 2,720 and 2,780 fps respectively. You may get a little more. As far as your accuracy figures go you...

    Liked On: 02-09-2020, 08:55 PM

14. 
    Magnetite liked post by grandpamac On thread : 6.5x55 SE Sanity Check

    Greetings Magnetite, Looks like your rifle gives a little more velocity than mine with your selection of components. I note that you are using a suppressor which some suggest gives more velocity so...

    Liked On: 01-09-2020, 08:17 PM

Page 7 of 7 First 1234567

• Jump to page: