Yeah definitely never use 4wd (as opposed AWD) on a high traction surface e.g. tarseal, I assumed gravel base... That's another advantage to older utes with manual hubs - the ability to select...
Liked On: 17-11-2019, 10:18 PM
The autos get about 10% worse economy in same model Hiluxes. Changes are rough + offroad in low it runs away (loses engine braking momentarily) down hills between gears if you don't use tiptronic to...
Liked On: 17-11-2019, 10:18 PM
can even do it by hand if your old school enough
Liked On: 16-11-2019, 06:58 AM
I use the same as a lot of the Yanks, wall anchors. Bought them dirt cheap off Amazon. They also feed out of a mag, only 1 though. Just keep turning them around then throw away. Will easily take 2...
Liked On: 15-11-2019, 08:17 PM
If you do polish the trigger, watch a few videos first. Dont change any angles, if you can find a piece of milled-steel with nice square/sharp edges, you can tightly-fold 1200 wet & dry over it, and...
Liked On: 14-11-2019, 07:20 PM
Well after a failed attempt to get 155gn eldm to shoot I have had some success. Big cheers to stug for putting me onto 125gn accubonds. Did a small ladder test starting at 43.5 going up in .5...
Liked On: 14-11-2019, 04:44 PM
Iv had an old USSR made toz (cock on closing) for perhaps 13 years. (to3 17-03 I think?) I really like it. Its lightweight, has dual extractors & very strong firing pin spring = super reliability....
Liked On: 13-11-2019, 01:19 PM
I have a full length suppressor on a single shot Yildiz 410 shotgun. Quiet and safe re ricochet risk. In my opinion the best option for lifestyle blocks bar none. I am killing rabbits out to 30m....
Liked On: 11-11-2019, 08:23 PM
When my mechanic son worked for a toyota dealership they used a book of standard charges for jobs like that. If they did it quicker the company won. If they did it slower the company probably still...
Liked On: 03-11-2019, 06:51 AM
My 601 243 had a pressure pad at the front of the foreend, but the stock must also have warped over the years as it was pressing in the side of the barrel too. Sanding off the side contact helped....
Liked On: 01-11-2019, 08:29 PM
I would give it a good clean, make sure the action and bottom metal are correctly mated and check for wear spots where metal on metal and address anything too proud or bed anything also it may...
Liked On: 01-11-2019, 08:22 PM
I would take the bull by the horns and trim it to 20" to get rid of the pitting, and you would get a recrown at the same time in any event. 2 birds with one stone. The .243 in 20" performs pretty...
Liked On: 01-11-2019, 08:18 PM
Our expectations of accuracy have gone up significantly over time. Our grandparents great grandparents depending your age would have been happy with 4 moa or less in a hunting rifle. Now we moan...
Liked On: 01-11-2019, 08:18 PM
After reading some of the guys long range rimfire exploits, I decided to put this together... 123136 Ruger rimfire target .22lr Tac vector 5-25 Burris 20moa offset rings Hardy suppressor ...
Liked On: 31-10-2019, 06:41 PM
AI it:cool:
Liked On: 30-10-2019, 08:25 PM