This was largely converted to Harleys apparently.
Liked On: 02-05-2022, 01:59 PM
Gee wiz, if that's the punishment, I would of kept all my AR's.
Liked On: 02-05-2022, 01:58 PM
Good idea. But I have grown fond of shooting cans filled with water. I have a wheely bin full of empties to shoot, and a contraption to fill 20 at a time, and a small trough with ballcock etc for...
Liked On: 01-05-2022, 01:08 PM
You should get into rimfire silhouette shooting. Standing, no rest/sling and ammo's cheap :thumbsup: Bloody good practice considering the targets are barely bigger than a credit card and your...
Liked On: 26-04-2022, 02:31 PM
Bloody rediculous aye. Nanny state at its worst AGAIN>>>>>> How on earth are young fellas supposed to learn all the good things about firearm safety, shooting, etc etc. Personally, Im so sick...
Liked On: 26-04-2022, 02:30 PM
Police range regulations (proposed) are another death knell - no under 16s on shooting ranges.
Liked On: 26-04-2022, 02:27 PM
Haha, jeezus I'd be lucky if it was a jw-15 . .
Liked On: 24-04-2022, 06:52 PM
Most likely your mold was either too cold or the lead was or both, they would be shootable but don't expect stellar results still not bad for a first attempt. Beeswax and lard is a traditional lube...
Liked On: 24-04-2022, 01:25 AM
Your mold is too cold, your alloy is too cold. Your alloy needs some tin and your mold needs a real good clean with a toothbrush and acetone. Then when youve done this look a getting sharply defined...
Liked On: 24-04-2022, 01:24 AM
Id just recast them next time, in my limited experience i think thats mainly from the mold being cold
Liked On: 24-04-2022, 01:23 AM
Just to stir the pot, from northland firearms dept, you do not need to fit a trigger lock if travelling directly to you shooting ground, the amendments explain this although the way it is written is...
Liked On: 23-04-2022, 12:19 PM
Pedestrians, and both types of cycles.
Liked On: 21-04-2022, 07:45 PM
Greetings All, At the moment I am sorting out some handloads put together by a now departed gentleman. This is something I have done a couple of times in recent years and this time there are labels...
Liked On: 19-04-2022, 11:06 AM
22-250 and call it done?
Liked On: 19-04-2022, 10:59 AM
[/B] Yup...if you want case life that is. Any case head extrusion into bolt recesses or stiff bolt lift or opening...if you are getting that you are over pressure and may only get 5 or less...
Liked On: 19-04-2022, 10:56 AM