Slightly envious of the guys for who lockdown gives them extra project time - no such luck here. Still, managed to pull this together on Sunday: https://i.imgur.com/BgIRdZ9l.jpg ...
Liked On: 29-08-2021, 01:14 AM
Slightly envious of the guys for who lockdown gives them extra project time - no such luck here. Still, managed to pull this together on Sunday: https://i.imgur.com/BgIRdZ9l.jpg ...
Liked On: 24-08-2021, 09:05 PM
Slightly envious of the guys for who lockdown gives them extra project time - no such luck here. Still, managed to pull this together on Sunday: https://i.imgur.com/BgIRdZ9l.jpg ...
Liked On: 24-08-2021, 08:20 PM
Slightly envious of the guys for who lockdown gives them extra project time - no such luck here. Still, managed to pull this together on Sunday: https://i.imgur.com/BgIRdZ9l.jpg ...
Liked On: 23-08-2021, 10:54 PM
Slightly envious of the guys for who lockdown gives them extra project time - no such luck here. Still, managed to pull this together on Sunday: https://i.imgur.com/BgIRdZ9l.jpg ...
Liked On: 23-08-2021, 10:31 PM
Thanks for the update. A bit disappointing, but no-one's fault; not Tuatahi's and certainly not yours so no need to feel guilty! Personally, I probably won't wait because the 'at least 12 months'...
Liked On: 15-08-2021, 07:04 PM
Inletting of barrelled action and bottom metal has gone as far as I'm going to take it on the mill. Time to break out the inletting black and sharpen up the chisels and scrapers for the final...
Liked On: 13-08-2021, 09:58 PM
One more post and this’ll be up to date with where I’m actually at. If I was writing this chronologically, there should actually be a post in between thinking the pattern stock was done and then...
Liked On: 13-08-2021, 09:39 PM
Not Totara anyway; this is the across-grain pattern I was looking for. Quite distinctive: 174634
Liked On: 09-08-2021, 06:44 PM
Not Totara anyway; this is the across-grain pattern I was looking for. Quite distinctive: 174634
Liked On: 09-08-2021, 06:05 PM
Some great work going on there. If a gun tap would do the job for you (it is a through hole you're talking about if I understand correctly?) I see CarbideNZ have M5x0.5 for $14 and M6x0.5 for...
Liked On: 07-08-2021, 03:52 PM
Sounds like you've identified a problem and have a plan to fix it. Better bedding may or may not help, but done properly it should never hurt. For your specific question around .22's needing a...
Liked On: 06-08-2021, 02:17 PM
Totara? That'd be a bit soft and free-splitting wouldn't it? Puriri would be strong, but probably not lightweight. Tanekaha would likely be good if you could find a piece.
Liked On: 05-08-2021, 08:16 PM
Just guessing here... but are you going to mount both scopes rigidly together so one is reference and one is test? If so, how are you planning to account for parallax in either scope at only 25m?
Liked On: 18-07-2021, 11:58 AM
Welcome to the forum. You must really rate their gear - I imagine shipping cost isn't small!
Liked On: 16-07-2021, 08:09 AM