rambo-6mmrem
Member

1784 Likes

Page 1 of 119 12345678910111213141551101 ... Last

• Jump to page:

1. 
   Jhon liked post by rambo-6mmrem On thread : found another 44/40 mold

   Ether or then Both would work equally as well I bet you could fill your mag half and half and not notice Id powder coat rater than a wax based lube for smokeless

   Liked On: 07-01-2026, 03:37 PM

2. 
   Micky Duck liked post by rambo-6mmrem On thread : Black Powder Supply

   The main 3 clubs are (tmla) taumarnui muzzle loaders probaly dane's local Rotorua black powder club Murcury bay black powder club There are several less active clubs about Attactched to pistol...

   Liked On: 04-01-2026, 07:42 PM

3. 
   Micky Duck liked post by rambo-6mmrem On thread : 44/40 questions

   Lol Was'nt intended that way. 44/40 is great Shooting factory ammo in 44/40 is a rich mans game though And the factory ammo you buy is pretty gutless As theres alot of old rifles arround ...

   Liked On: 24-12-2025, 05:47 PM

4. 
   Micky Duck liked post by rambo-6mmrem On thread : 32-20 Winchester model 1892 load data for available powders?

   I dont shoot alot of smokeless Mainly black My 32-20's are all genuine antiques Although i do feel comfortable shooting mild cowboy action type loads i dont realy get the opportunity as all the...

   Liked On: 23-12-2025, 05:56 PM

5. 
   Oscar liked post by rambo-6mmrem On thread : boretech eliminator

   no I wouldn't doesn't strike me as a product that would be very good at rust prevention (even though it says so on the label) remember NZ climate is extremely hard on firearms Unlike where the...

   Liked On: 01-12-2025, 03:30 PM

6. 
   superdiver liked post by rambo-6mmrem On thread : Short barrel 6.5 creedmoor - who's done it / how does it go?

   fuck thats slow for a 6.5 way better off with a 160 ish grain from a 308 if your only going to be doing 24-2500 and i hate 308

   Liked On: 23-11-2025, 11:09 PM

7. 
   Huk liked post by rambo-6mmrem On thread : Speer gold dot

   That particular shot was on a fellow yearling about 100m Shot about 5-6 deer with them now and all of them have been awsome as far as bullet performance goes Not quite as Devastating as the...

   Liked On: 22-10-2025, 01:13 PM

8. 
   Marty Henry liked post by rambo-6mmrem On thread : .577/450 Martini

   when you clean it clean it upside down so the shit falls onto the ground and not into the action For solvent use, room temperature water with a bit of dish soap. Boiling water is an old wives'...

   Liked On: 17-09-2025, 10:05 PM

9. 
   omark liked post by rambo-6mmrem On thread : .577/450 Martini

   when you clean it clean it upside down so the shit falls onto the ground and not into the action For solvent use, room temperature water with a bit of dish soap. Boiling water is an old wives'...

   Liked On: 17-09-2025, 08:37 PM

10. 
    quentin liked post by rambo-6mmrem On thread : Cleaning brass.

    Seems alot more hassle than the wet tumbler And no where near as good results Certainly gets them clean enough though… cheap and easy and doesn’t require a $3-600 tool which is always good

    Liked On: 08-09-2025, 04:11 PM

11. 
    Russian 22. liked post by rambo-6mmrem On thread : Who can machine AR barrels for straight pull?

    I would be thinking $1000 that’s a pretty good price I’ve rebarreled quite a few bolt action and single shot rifles Comes out to about that number including a good quality barrel blank which is...

    Liked On: 27-07-2025, 09:16 PM

12. 
    kristopher liked post by rambo-6mmrem On thread : Who can machine AR barrels for straight pull?

    I would be thinking $1000 that’s a pretty good price I’ve rebarreled quite a few bolt action and single shot rifles Comes out to about that number including a good quality barrel blank which is...

    Liked On: 27-07-2025, 07:23 AM

13. 
    imaca liked post by rambo-6mmrem On thread : Cracking the Code on another Double Rifle

    Yeah i also shoot alot of guns for the 1st time The biggest thing in my opinion is to insure a safe rifle Some rifles you just know they are fine as soon as you pick them up Others require a...

    Liked On: 26-07-2025, 04:32 PM

14. 
    Micky Duck liked post by rambo-6mmrem On thread : Cracking the Code on another Double Rifle

    Yeah i also shoot alot of guns for the 1st time The biggest thing in my opinion is to insure a safe rifle Some rifles you just know they are fine as soon as you pick them up Others require a...

    Liked On: 26-07-2025, 12:36 PM

15. 
    Micky Duck liked post by rambo-6mmrem On thread : Cracking the Code on another Double Rifle

    Was designed for buckshot but it will shoot a ball aswell as above The idea of straight rifling was to keep the spread of buckshot to a minimum as far as I understand Id say this rife was...

    Liked On: 26-07-2025, 12:34 PM

Page 1 of 119 12345678910111213141551101 ... Last

• Jump to page: