Rated M for Magnum
Member

390 Likes

Page 20 of 26 First ... 67891011121314151617181920212223242526 Last

• Jump to page:

1. 
   Rated M for Magnum liked post by grandpamac On thread : 7mm08 120 grain VMAX loads

   Greetings Again Gerardo and Rated M for Magnum, 50 plus years ago there was a belief that projectiles could be spun too fast and accuracy would suffer. This may have been true at the time but todays...

   Liked On: 22-05-2021, 02:27 PM

2. 
   Rated M for Magnum liked post by grandpamac On thread : Jump

   Greetings Wide Range, The Nosler 160 grain partition projectile has a much longer bearing surface than the 160 or 162 grain spitzer boat tail. This produces more pressure. You can see this by...

   Liked On: 23-02-2021, 05:48 PM

3. 
   Rated M for Magnum liked post by Woody On thread : 220 grain ELD-X in 308 win

   I have a good load using 178gn ELDX over 42 gn AR2208/ Norma brass. 2620fps / 25" bbl. Knock about 30fps per inch reduction in bbl length. 2.86" COAL in my chamber.

   Liked On: 07-12-2020, 11:54 PM

4. 
   Rated M for Magnum liked post by Flyblown On thread : 220 grain ELD-X in 308 win

   If you can push them around 2,300fps+ they should stabilise, otherwise marginal.

   Liked On: 28-11-2020, 08:34 PM

5. 
   Rated M for Magnum liked post by Woody On thread : 220 grain ELD-X in 308 win

   Ok but I vent used them enough on game to give expert opinion. I' m sure others on the forum will have had more experience with themthan I.

   Liked On: 27-11-2020, 10:43 PM

6. 
   Rated M for Magnum liked post by Micky Duck On thread : 220 grain ELD-X in 308 win

   they will stabalise BACKWARDS.....bit of a bugger about expansion though LOL.

   Liked On: 25-11-2020, 09:44 PM

7. 
   Rated M for Magnum liked post by Micky Duck On thread : To Bushpig or not to Bushpig this is the question what are your thoughts?

   nothing at all wrong with poohseventy.... Duleys have been using one as bush rifle as sponsers wanted factory rifle and ammo last season...they ran the numbers and poohseventy WON HANDS DOWN........

   Liked On: 31-10-2020, 09:57 AM

8. 
   Rated M for Magnum liked post by GWH On thread : Date night with the wife

   I treated the wife to a special date night last night. Dropped the kids off to my parents and off we went! We were banging away for two whole hours! She absolutely loved it! She nailed...

   Liked On: 07-10-2020, 10:37 PM

9. 
   Rated M for Magnum liked post by Larrygoat On thread : 1000m on a "budget"

   When your car is 27 years old the value is negligible, but i should have included petrol costs driving to and from the target ��

   Liked On: 03-10-2020, 09:26 PM

10. 
    Rated M for Magnum liked post by woods223 On thread : Winchester model 70 3 position safety problem

    Rated M for Magnum.I think you're on to it about worn/machined cocking piece or sear. To my eye, I admit I've had a couple of bourbons with meal, the surface on the cocking piece in top photo looks...

    Liked On: 02-10-2020, 04:46 PM

11. 
    Rated M for Magnum liked post by Micky Duck On thread : Winchester model 70 3 position safety problem

    I couldnt help more with the safety issue as the one on my poohseventy has been used maybe a dozen times in over 30 years....mostly to strip bolt...I hunt bolt half open,always have and probably...

    Liked On: 02-10-2020, 04:46 PM

12. 
    Rated M for Magnum liked post by grandpamac On thread : IMR 4064 in 7mm08

    Greetings, Shot some comparative loads of IMR4064 (old manufacture) and AR2208 in my .308 yesterday. IMR4064 chronographed faster than AR2208 so a bit of caution might be required in your 7mm-08....

    Liked On: 24-09-2020, 08:31 PM

13. 
    Rated M for Magnum liked post by grandpamac On thread : IMR 4064 in 308

    Greetings Rated M for Magnum, I have used Dupont IMR4064 for decades in the .308 and it should be fine in the 7mm-08. I found a definite improvement in accuracy with increases in loads. The .308...

    Liked On: 20-09-2020, 10:31 AM

14. 
    Rated M for Magnum liked post by DBD On thread : IMR 4064 in 7mm08

    It's the equivalent to 2208 in the adi manual, 120gn Nosler bt with 45gn will see you flying...no more bunny!

    Liked On: 20-09-2020, 08:32 AM

15. 
    Rated M for Magnum liked post by shooternz On thread : IMR 4064 in 308

    Hornady list IMR 4064 with a 162 grain from 32.3 to 39.6 very close to 2208, I used it years ago for target loads in .308's with 168 MK great powder a little coarse grained

    Liked On: 18-09-2020, 12:33 PM

Page 20 of 26 First ... 67891011121314151617181920212223242526 Last

• Jump to page: