Definitely don't start with a full case of Trail Boss you will get a shotgun pattern most loads that are shooting well are between 8.0 and 9.0 grains with no fillers or drilled out flash-holes and...
Liked On: 03-03-2017, 12:21 PM
Definitely don't start with a full case of Trail Boss you will get a shotgun pattern most loads that are shooting well are between 8.0 and 9.0 grains with no fillers or drilled out flash-holes and...
Liked On: 03-03-2017, 12:07 PM
Definitely don't start with a full case of Trail Boss you will get a shotgun pattern most loads that are shooting well are between 8.0 and 9.0 grains with no fillers or drilled out flash-holes and...
Liked On: 03-03-2017, 09:57 AM
I am interested in this build I could do with a .44 mag to test my cast bullets in at present I have to rely on feedback from others, friwi is right do your basic trials with the standard set up I...
Liked On: 24-02-2017, 11:52 AM
The 17 grs looks good definitely not subsonic
Liked On: 18-02-2017, 10:27 PM
That is your best bet the more people that complain to their boss can only help, I complained about a different matter and got a reply from some flunky who passed it on to the commissioner of...
Liked On: 06-02-2017, 12:09 PM
Check out my listing on Trade Me #1251543112 The recovered bullet is from a Sika hind shot at 50 metres with a .308 doing 1050fps all recovered bullets look the same, the only jacketed bullet ...
Liked On: 06-02-2017, 07:51 AM
Check out my listing on Trade Me #1251543112 The recovered bullet is from a Sika hind shot at 50 metres with a .308 doing 1050fps all recovered bullets look the same, the only jacketed bullet ...
Liked On: 04-02-2017, 04:13 PM
Good move nothing like a blast of hot gas in the face to tell you to back off
Liked On: 01-02-2017, 05:24 PM
ADI data can be a little conservative but I would be cautious about going up in one grain steps, shoot what you have loaded and see what the accuracy is like at 44 grs you may have reached the...
Liked On: 01-02-2017, 06:55 AM
ADI data can be a little conservative but I would be cautious about going up in one grain steps, shoot what you have loaded and see what the accuracy is like at 44 grs you may have reached the...
Liked On: 26-01-2017, 03:11 PM
ADI data can be a little conservative but I would be cautious about going up in one grain steps, shoot what you have loaded and see what the accuracy is like at 44 grs you may have reached the...
Liked On: 24-01-2017, 07:20 PM
I like being stuck in the shed stops me going to the pub
Liked On: 22-01-2017, 08:50 AM
If you want to avoid gas checks get a mould that is designed as a plain base moulds cut for gas checks don't shoot very good with out them, for sub loads get a HP or a large flat point some custom...
Liked On: 22-01-2017, 08:50 AM
I like being stuck in the shed stops me going to the pub
Liked On: 22-01-2017, 07:45 AM