Would 6.5-284 cases fit and feeds of your magazine? That might be a good alternative.
Liked On: 30-12-2020, 11:08 AM
If it was me id do whatever the fuk i like its my money i earnt it and ill spend it how i want. I had a 6.5 06 built and i love it. Just one of the many rifles in the cupboard. You can make the 6.5...
Liked On: 30-12-2020, 11:08 AM
If it was me, I'd keep the 25-06, great calibre, capable of way more than 300 if you have the trigger time, plenty of projectiles that kill shit. And I would build a 6.5-06 to the specs I want for...
Liked On: 30-12-2020, 09:19 AM
Mark and Sam after work did a comparison between a 6.5 Saum and 6.5 06 AI. With the exact same powder charge and barrel the Saum produced 200 fps more velocity. So if I was changing barrels I...
Liked On: 30-12-2020, 09:18 AM
maybe just measure a case before you resize it to make sure your not stretching it. and just check its not putting a flat spot in the neck when ejecting the case some rifles will do that
Liked On: 14-12-2020, 09:54 PM
Take up an offer to show you. Reading instructions watching you tube is fine but the best training for anything is being shown by some one who is competent and confident. It will turn night into...
Liked On: 14-12-2020, 07:33 AM
I've had a fair bit of time in lieu owing lately due to some solid weeks at work. I had a few too many days for my bosses liking and the mrs gave me the green light so the solution was to go bush....
Liked On: 08-12-2020, 08:45 AM
Looking at the photo, I cant see any quality feed or feed country, perhaps you are too keen and fit, climbed too high above the feed ?. Are there any creeks with scrubby faces and gully heads,...
Liked On: 07-12-2020, 06:11 PM
Well, got out and the weather held for the most part. Lots of glassing, but nothing seen. Dog enjoyed it! 155539
Liked On: 07-12-2020, 06:11 PM
Greetings Bos, From your above reply I assume that you have the standard 6.5-06 chamber rather than an improved version. If this is the case then sizing the neck to to 6.5 mm and trimming to the...
Liked On: 04-12-2020, 10:56 AM
Depends on what you are fireforming to, and what are you starting with. If it's an Ackley from the parent case then make sure you have a crush-fit when chambering at the neck shoulder junction....
Liked On: 04-12-2020, 10:53 AM
I normally use the "pre ai" factory cartridge load with a cup and core at paper, but you will find guys using small amounts of shotgun powder with wads of various material, cream of wheat etc.
Liked On: 04-12-2020, 10:53 AM
I’m being sarcastic ahaha
Liked On: 28-11-2020, 06:58 PM
2217 or 2225, I will be working up a load when 168gn bergers are available again.
Liked On: 26-11-2020, 07:00 PM
I've literally shot a pig out of fright. Crawling on hands and knees through a little tunnel in the scrub, noises everywhere. One of the killer 200lb boars I had seen appeared in front of me and was...
Liked On: 26-11-2020, 05:35 PM