takbok
Member

1170 Likes

Page 36 of 78 First ... 2223242526272829303132333435363738394041424344454647484950 ... Last

• Jump to page:

1. 
   takbok liked post by Philipo On thread : Kimber 16in 7mm08 loads

   Just a side note on running heavier pills at slower speeds for down range power, basic specs for the ARX 125g @ 2635fps MV energy 1927 ft-lb @ 400 yards 827 ft-lb 155g @ 2435fps MV energy...

   Liked On: 31-05-2020, 08:23 AM

2. 
   takbok liked post by Wingman On thread : 6x45 Rem barrel

   I just ordered a new custom 6x45 reamer today with zero free bore so it should shoot a wider range of bullets better with less jump.

   Liked On: 31-05-2020, 03:16 AM

3. 
   takbok liked post by quadhunter260 On thread : 6x45 Rem barrel

   223s are girly til theyve had to the op to 6x45 or 6TCU via Doc Wingman 😎

   Liked On: 31-05-2020, 02:24 AM

4. 
   takbok liked post by Ryan_Songhurst On thread : What in the world?

   Dents caused by pressure going up the ouside of the case after case head separated

   Liked On: 30-05-2020, 09:44 PM

5. 
   takbok liked post by Moa Hunter On thread : .270 Projectiles Lagging Behind

   The reason for the lower BC bullets is that the vast majority of 270's are 1 in 10 twist so anything more than 140gr is borderline to stableise

   Liked On: 28-05-2020, 10:01 PM

6. 
   takbok liked post by Wingman On thread : Took the .410g for a walk

   Funny you should say that, I run the 3"winchester #6 in the first barrel with an improved choke and a 3" #4 in the second barrel full choke. I couldnt find any #4s in the super X so picked up a box...

   Liked On: 27-05-2020, 10:11 PM

7. 
   takbok liked post by Wingman On thread : Took the .410g for a walk

   Decided to take the .410g for a stroll up the creek on the boundary last night. I barely got 50m before kicking up a nice cock pheasant, I got a shot off at about 40m and it dropped clean but...

   Liked On: 27-05-2020, 10:10 PM

8. 
   takbok liked post by GWH On thread : Reloading the .223r to low velocity

   16gr gave 2350 fps and 18gr gave 2594 fps. Those two powder charges werent quite as tight on the grouping but still quite acceptable at .6 inch, the 14gr load was .3 inch!

   Liked On: 27-05-2020, 09:01 AM

9. 
   takbok liked post by GWH On thread : Reloading the .223r to low velocity

   Yep ive downloaded 223 55gr to around 2100 fps very accurately using 14gr of IMR 4198. https://uploads.tapatalk-cdn.com/20200526/80491767500ad3a6fda50d7ca42613b9.jpg

   Liked On: 27-05-2020, 09:01 AM

10. 
    takbok liked post by Ryan_Songhurst On thread : New boomstick... what a bloody drama

    Just doing some load development this morning... pretty stoked with this load, its nowhere near max but 2500fps with the 270gr speer and I think I've got the hang of shooting it now :) that'll do me!...

    Liked On: 26-05-2020, 08:00 PM

11. 
    takbok liked post by Tahr On thread : Silly old paddock hunters. Pffttt...

    First post Covid hunt for the the old buggers. Brian shot a nice Fallow. 240 yards. 6.5-06. Restocked the freezers. Some for charities. Some sausages and salamis. 139971 139972

    Liked On: 26-05-2020, 07:36 AM

12. 
    takbok liked post by akaroa1 On thread : Self isolation gun projects

    And a curved top rib test Went better than the flat one Lots to learn 140759

    Liked On: 25-05-2020, 08:50 PM

13. 
    takbok liked post by akaroa1 On thread : Self isolation gun projects

    Got some silver solder and non corrosive flux in hand So did my first laying top rib test piece Can only improve with practice. Certainly nice and strong and can't get it off 140733 140735

    Liked On: 25-05-2020, 08:50 PM

14. 
    takbok liked post by JoelA On thread : New Member to NZHS

    Hey all, 24 year old guy keen on getting into hunting, recently moved to the mighty Waikato from Auckland. Been on a handful of hunts with mates, and the standard possum and rabbit shooting - so...

    Liked On: 25-05-2020, 08:01 AM

15. 
    takbok liked post by dannyb On thread : Marlin 30-30 setup

    so I picked up my Marlin late last night and mounted the scope and rail, I levelled the scope and torqued it up this morning then took it to the range to zero it. Well I've never had it so easy.......

    Liked On: 24-05-2020, 11:05 PM

Page 36 of 78 First ... 2223242526272829303132333435363738394041424344454647484950 ... Last

• Jump to page: