Three O'Three
Member

56 Likes

Page 3 of 4 First 1234 Last

• Jump to page:

1. 
   Three O'Three liked post by johnd On thread : Victory Knives

   I like my dick. It's a boner, holds edge well better than my knifekut it's a boner too. I don't take my dick hunting. I prefer to use a bacho in the bushes.

   Liked On: 13-03-2022, 11:34 PM

2. 
   Three O'Three liked post by bumblefoot On thread : Eggington shepherds sharpening steel

   This should help me find it if I drop it! 190695

   Liked On: 20-02-2022, 08:10 PM

3. 
   Three O'Three liked post by bumblefoot On thread : Eggington shepherds sharpening steel

   Three O'Three I just bought another drop point hunter today in a "very hard to lose" colour.... ;) 190440

   Liked On: 17-02-2022, 10:17 PM

4. 
   Three O'Three liked post by longshot On thread : Scope adjustment issues

   I had the same frustrations a while back with a G1 NV scope. It was new and still under warranty at the time. To establish that it was the scope and not the rifle I put a piece of picatinny rail...

   Liked On: 30-12-2021, 11:05 PM

5. 
   Three O'Three liked post by Driverman On thread : Chamber ringing

   AP70 is a good powder for reduced loads in 303 and 308 . Keep experimenting.The consensus among cast boolit reloaders is that ringing a chamber is caused by using a filler that has been tamped down...

   Liked On: 27-10-2021, 06:04 PM

6. 
   Three O'Three liked post by Marty Henry On thread : Chamber ringing

   Look back through old Lyman manuals from the 60s, light loads 5 to 10 gr of shotgun powders, bullseye, unique etc no mention of case fillers. Trust the old timers on this.

   Liked On: 26-10-2021, 09:33 PM

7. 
   Three O'Three liked post by 40mm On thread : HELP! Where's the Wheel Weight lead gone?

   Sure are!

   Liked On: 04-10-2021, 11:31 PM

8. 
   Three O'Three liked post by oneshot On thread : Show me your knives

   I may have gotten carried away in the last couple of weeks. I do a lot of butchery so it was time I got some more Victory knives. I am extremely pleased with The Jack knife from Nga that arrived. And...

   Liked On: 15-09-2021, 07:47 PM

9. 
   Three O'Three liked post by Shearer On thread : Show me your knives

   Just finished a lockdown project that was rudely interrupted by another addition to the family. 178186

   Liked On: 12-09-2021, 12:41 AM

10. 
    Three O'Three liked post by cambo On thread : Air rifle section?

    Is it time for an air rifle section? A lot more using pcp's for pest control in suburban and other areas a firearm can't be used. Plus, wouldn't mind seeing more of the airgunners missions.

    Liked On: 29-08-2021, 04:17 PM

11. 
    Three O'Three liked post by Quackers On thread : Load for the Blue, Winchester 12 gauge WAA 1224 wads

    From memory blue wads were for 1 3/16 loads. Like 34gram unusual load. I had a whole heap I sold a while back.

    Liked On: 28-08-2021, 02:12 PM

12. 
    Three O'Three liked post by Sh00ter On thread : Show me your knives

    175807 The missus thinks I might have a problem, I agree theres definately not enough, lol.

    Liked On: 22-08-2021, 11:28 PM

13. 
    Three O'Three liked post by Tahr On thread : Show me your knives

    This Havlon is always in my day pack. Good for head skinning. 175660

    Liked On: 21-08-2021, 03:43 PM

14. 
    Three O'Three liked post by Friwi On thread : threading odd muzzle

    @ 303, when we re open after the lockdown, bring your rifle along at our workshop at dpt and I can take measurements and see what we can do for you.

    Liked On: 21-08-2021, 12:03 AM

15. 
    Three O'Three liked post by akaroa1 On thread : threading odd muzzle

    Sort of like this175606

    Liked On: 20-08-2021, 08:58 PM

Page 3 of 4 First 1234 Last

• Jump to page: