Tui4Me
Member

73 Likes

Page 1 of 5 12345 Last

• Jump to page:

1. 
   Tui4Me liked post by XR500 On thread : Advice wanted: Two stoke outboard tune up in Taupō

   If the old owner has 'played' with the carbs they may take an experienced hand to get them back running right. Idle circuits on 2 stroke carbs work the opposite to 4 strokes: they are air orientated,...

   Liked On: 01-10-2025, 10:07 PM

2. 
   Tui4Me liked post by Quackers On thread : Advice wanted: Two stoke outboard tune up in Taupō

   New plugs. Check timing adjust carb decent fuel not much else to them

   Liked On: 01-10-2025, 08:56 PM

3. 
   Tui4Me liked post by ONYVA On thread : Advice wanted: Two stoke outboard tune up in Taupō

   Magnum Marine ph 07 377 1356 very experienced marine mechanics but are normally quite busy.

   Liked On: 01-10-2025, 06:10 PM

4. 
   Tui4Me liked post by Barry the hunter On thread : Advice wanted: Two stoke outboard tune up in Taupō

   you are right there Russian 22 we ran about 6 two strokes at Waikaremoana new plugs clean fuel and full noise for a while cured a lot of evils - not being run for awhile was biggest problem...

   Liked On: 01-10-2025, 06:10 PM

5. 
   Tui4Me liked post by Russian 22. On thread : Advice wanted: Two stoke outboard tune up in Taupō

   to be honest there is not much to go wrong with a 2 stroke. new spark plugs, any oil that is not valvoline and run some fuel system cleaner in it. give it a good thrash and if that doesn't fix it it...

   Liked On: 01-10-2025, 06:10 PM

6. 
   Tui4Me liked post by BRADS On thread : Advice wanted: Two stoke outboard tune up in Taupō

   Taupo powersports would be worth a call, very good service even on the older 2 bangers Sent from my SM-S936B using Tapatalk

   Liked On: 01-10-2025, 06:10 PM

7. 
   Tui4Me liked post by Barry the hunter On thread : Advice wanted: Two stoke outboard tune up in Taupō

   you could do a few things yourself to save you some money - new spark plugs- shine a torch into the petrol tank to make sure nice and clean i.e no rust flakes or debris floating around - they are...

   Liked On: 01-10-2025, 06:10 PM

8. 
   Tui4Me liked post by Rushy On thread : Fishing tomorrow!

   Maca49 give this man the local knowledge good oil.

   Liked On: 02-07-2025, 08:00 PM

9. 
   Tui4Me liked post by 30late On thread : Mangaturutu hut Kawekas

   Four of us flew into Mangaturutu hut on sat April 19th with Midwest helicopters. We were lucky to get in with the wind and low cloud , our pilot Owen had to put the helicopter down on the large...

   Liked On: 03-05-2025, 11:05 PM

10. 
    Tui4Me liked post by EmpireSafaris On thread : Demise of the 7mm Rem Mag

    I’ve been shooting 7mm rem mag for 30 years and will for at least another 30. Mines an old heavy Sako too https://i.postimg.cc/hPQbD4LK/IMG_7918.jpg (https://postimages.org/)

    Liked On: 19-09-2024, 11:02 PM

11. 
    Tui4Me liked post by ojc2 On thread : Thermal Optics under scrutiny?

    "I don't like it, so others shouldn't be allowed it".... jeez where have I heard that recently?

    Liked On: 16-09-2024, 09:12 PM

12. 
    Tui4Me liked post by ojc2 On thread : Thermal Optics under scrutiny?

    Cheers, just found it now. https://rodandrifle.co.nz/articles/articles/editors-letter-september-october-2024/ "Recently, I attended my first meeting of the Firearms Community Advisory Forum; it’s...

    Liked On: 16-09-2024, 09:12 PM

13. 
    Tui4Me liked post by 7mmwsm On thread : Is cray fish overrated or am I cooking it wrong?

    Has to be cooked in salt water. From the sea not fresh water with salt added.

    Liked On: 23-08-2024, 01:20 PM

14. 
    Tui4Me liked post by 7mmsaum On thread : Is the new 7mm PRC a lemon ?

    We carried suppressed Senderos into back ridge many times The rums certainly did what they were meant to do, but they used 101-104g of US869 to do it :) We then went to Titanium’s then...

    Liked On: 05-08-2024, 10:32 PM

15. 
    Tui4Me liked post by Micky Duck On thread : Bahco Knives

    Ten times as sharp......tui anyone???

    Liked On: 26-07-2024, 10:39 PM

Page 1 of 5 12345 Last

• Jump to page: