Greetings Joelhenton, I don't have any data for CFE223 but it may be a little fast for this application. The belief that you need a faster powder for shorter barrels is a bit of a fable although...
Liked On: 17-02-2020, 06:33 PM
Just don’t give it to puffin to review, you will know more about it than you thought possible, but may never get to use it.
Liked On: 31-01-2020, 05:11 PM
Many years back when i was a foreman for a construction company i had given couple young guys many many warnings about texing at work. It was out of control and had said i catch you again am going to...
Liked On: 27-01-2020, 02:11 PM
Spend a great couple of ours with some complete strangers at the Taupo range today, sighting in my 17hmr, while the other two where wacking a 270 and 6.5. I had a spare iPhone 7 that had caused me...
Liked On: 27-01-2020, 02:08 PM
Yes the military are the ones who really know this stuff and how to predict it. So in essence, a group that is dead on at 100 might strike left or right at 600. I understand it that if someone wants...
Liked On: 25-01-2020, 10:28 AM
My understanding of the lighter lower / heavier higher was as the barrel lifts in angle with recoil, the lighter bullet is out of the muzzle faster and the heavier one is in the barrel fractionally...
Liked On: 25-01-2020, 10:27 AM
Recently had my security check because of a change of address. Got a phone call on a Sunday morning, asked if today was ok, told him yes. About an hour and a half later he turned up after a long...
Liked On: 22-01-2020, 11:19 AM
Here's the last one (for the moment), I promise :P These are the results from 100m. 127575 127576 127577 127578 And here's the only groups I've shot @ 150m.
Liked On: 07-01-2020, 10:29 AM
I was just reading somewhere about that and that there is something with the rimmed cartridges and extractor having a different behavior to a rimless due to the extractor being outside the diameter...
Liked On: 07-01-2020, 10:21 AM
Hi just noticed this thread. If its any help the 95gr I make has a BC of .450 & the 105gr I make for the 10" twist in most 243's which is a shorter bullet than the 105gr &112gr Low drag bullets I...
Liked On: 06-01-2020, 05:02 PM
Greetings 6.5, At least you have the calibre sorted. The 6.5 .284 should tick all your boxes, good cases, plenty of load data etc but it may not be what you are looking for. I sense that you may be...
Liked On: 05-01-2020, 07:12 PM
That's good if you have lots of disposable income and a stock of barrel blanks in your cupboard plus a good gunsmith just waiting to do your rebarreled. Also barrels, particularly in the hot 6.5s...
Liked On: 05-01-2020, 06:05 PM
With any AI rounds just use the standard parent case loads as starting / mild loads. They will shoot slower (less pressure) than the parent case because of the greater case capacity in the AI. The...
Liked On: 05-01-2020, 06:04 PM
I don't know that I'd say spin drift is basically nothing. For example ( probably not the best ) a .223 cal. 55gr projectile, BC 0.235, MV 2780 fps, zeroed @ 200yds. Using Strelok Pro the results at...
Liked On: 02-01-2020, 07:52 PM
I've got several Mec shot shell loaders, sitting in the shed in Bell block, Cant remember what model Mec's they all are, Think the 20ga might be a grabber, and I have a sizemaster in 12ga, and 28ga, ...
Liked On: 01-01-2020, 05:28 PM