yogi
Member

125 Likes

Page 2 of 9 First 123456789 Last

• Jump to page:

1. 
   yogi liked post by grandpamac On thread : Case head separation imminent

   Greetings All, Totally agree with measuring shoulder bump especially on belted cases. Setting back the shoulder by feel on a belted case can result in the shoulder being set too far back if there is...

   Liked On: 09-11-2022, 04:56 PM

2. 
   yogi liked post by veitnamcam On thread : Case head separation imminent

   Good reply above from Grandpamac. Check the rest of your cases, if they are relatively clean on the outside you can usually see the line but definitely would be worth checking them all with a...

   Liked On: 09-11-2022, 04:55 PM

3. 
   yogi liked post by grandpamac On thread : Case head separation imminent

   Greetings Padox, Congratulations you have identified the problem. My son lent me some Hornady headspace comparators and some sets of the Redding competition shell holders earlier this year. I had...

   Liked On: 08-11-2022, 03:05 PM

4. 
   yogi liked post by Dicko On thread : Case head separation imminent

   Padox, was the first firing as factory ammo in the same rifle as the next one or two firings? I’ve had case separations after two firings in my .30/06. First firing in a different rifle to the...

   Liked On: 08-11-2022, 03:04 PM

5. 
   yogi liked post by veitnamcam On thread : Case head separation imminent

   Most full length Sizing die instructions tell you to wind the die down to the shell holder and then + another 1/4 or 1/2 turn. This will produce normally brass that should chamber in most rifles of...

   Liked On: 08-11-2022, 03:04 PM

6. 
   yogi liked post by veitnamcam On thread : Case head separation imminent

   Case head separation,what to look for and how to avoid it comes up fairly often on here so when prepping some of my "beater brass" today I found one and thought I would section it to show what to...

   Liked On: 08-11-2022, 03:04 PM

7. 
   yogi liked post by Harryg On thread : Venison shanks?

   Here's some of the other recipe's he cooked up for us 185960 185961 185967

   Liked On: 25-10-2022, 05:22 PM

8. 
   yogi liked post by Harryg On thread : Venison shanks?

   Hi Ryan At our last NZDA we had a chef come along and cook up some venison dish's here his take on braised shanks they were bloody good Hope the photo come's through if not PM your number and I'll...

   Liked On: 25-10-2022, 02:07 PM

9. 
   yogi liked post by Shearer On thread : Thermal photos

   Some naughty grass thieves. 208408 208409

   Liked On: 20-10-2022, 04:15 PM

10. 
    yogi liked post by The Hunters Club On thread : RST Hunters Club - New Series

    Hey team, Cameraman Dave here once again for my annual heads up... Our new series begins Wednesday August 10th, 8.30pm on Prime TV, or if you prefer, you can watch it via the catch up service...

    Liked On: 11-08-2022, 04:16 PM

11. 
    yogi liked post by Flyblown On thread : New Hilux Fuel Consumption

    Indeed. I think we need to also get a bit of a reality check going here. Measuring fuel consumption is a relatively exact science. As I mentioned earlier and as mentioned by @hotbarrels...

    Liked On: 28-06-2022, 09:33 PM

12. 
    yogi liked post by zeropak On thread : Pard NV 007s review

    So I recently purchased on of the new model Pard 007s clip ons. I have owned one of the earlier model 007v Pards and my experience with that was not as good as expected, The extra length it added to...

    Liked On: 28-06-2022, 09:12 PM

13. 
    yogi liked post by Micky Duck On thread : The dinner plate challenge

    years ago I attended a triagle shoot at the nzda in Timaru...held in pleasant point...a novelty shoot was held later in day...howling wind from right to left and a chammy target at 50 yards,5 shots...

    Liked On: 27-06-2022, 09:46 PM

14. 
    yogi liked post by Micky Duck On thread : The dinner plate challenge

    I tend to disagree for a single round.........you are going to be up and bang.....no time to worry about recoil,and standing the recoil is going to be felt heaps less than prone as body can sway with...

    Liked On: 27-06-2022, 09:46 PM

15. 
    yogi liked post by Matt2308 On thread : Haast/Wanaka Blocks

    Our party of 4 had Falls Creek first period. We asked the pilot who was contracting to the company we flew in with if any WARO had been taking place and was told it had been hammered in the weeks...

    Liked On: 10-05-2022, 04:38 PM

Page 2 of 9 First 123456789 Last

• Jump to page: