zimmer
Member

1490 Likes

Page 7 of 100 First 12345678910111213141516171819202157 ... Last

• Jump to page:

1. 
   zimmer liked post by 338MAN mk2 On thread : 10-Ring

   RIP mate, and may the stags be closer and the hills flatter where you are now

   Liked On: 10-11-2023, 03:55 PM

2. 
   zimmer liked post by johnd On thread : Neck tension

   https://youtu.be/mPhHAsYmcMg?si=d-cToI0u2x_Gsdsv

   Liked On: 10-11-2023, 03:38 PM

3. 
   zimmer liked post by ChrisW On thread : Comparing the old with the new.

   I think part of is that modern rifles use more stamped and cast parts (not to mention plastic), whereas almost everything on the old guns is machined. Everything just gives the aura of quality as the...

   Liked On: 10-11-2023, 12:15 PM

4. 
   zimmer liked post by akaroa1 On thread : Comparing the old with the new.

   This will be good ! I will watch and listen before I comment on Really Old vs New

   Liked On: 09-11-2023, 08:41 PM

5. 
   zimmer liked post by lee308 On thread : Chrono thoughts

   https://www.nzhuntingandshooting.co.nz/f10/start-review-bulletseaker-longseeker-com-replacement-labradar-87071/index3.html#post1498939

   Liked On: 09-11-2023, 09:00 AM

6. 
   zimmer liked post by Rushy On thread : Hi All, Newbie(ish) from Hawkes Bay

   Ha ha ha yeh what the hell is that about aye? An alternate Rushy colour spectrum community to the LGBTQ rainbow lot would be the communist (red) Dutch (orange) cowardly (yellow) envious (green) sad...

   Liked On: 08-11-2023, 08:34 PM

7. 
   zimmer liked post by Rushy On thread : Hi All, Newbie(ish) from Hawkes Bay

   Yup! Hence my reference above.

   Liked On: 08-11-2023, 07:33 PM

8. 
   zimmer liked post by madjon_ On thread : 22lr Barrel Chopping Question.

   Binned the whole project when the off center bore reared its ugly head.Later modle shit jw15

   Liked On: 08-11-2023, 02:29 PM

9. 
   zimmer liked post by akaroa1 On thread : Sanblasting cabinet. SCA ?

   I went with a big free standing Ironside 220 litre cabinet sand blaster Just running some glass at the moment that came with it But will switch to garnet when I get to town and pick some up ...

   Liked On: 08-11-2023, 12:50 PM

10. 
    zimmer liked post by 6x47 On thread : Setting your eye relief

    Unless you want a Weatherby eyebrow, it's best to set it for prone shooting. I guess if it's strictly a bush gun that you only shoot standing. then it makes sense to set it for that. Overall, I feel...

    Liked On: 08-11-2023, 08:43 AM

11. 
    zimmer liked post by johnd On thread : Opinel folding knives

    If only Bacho made a folder....we could have a 50 page thread �� ��

    Liked On: 07-11-2023, 07:56 PM

12. 
    zimmer liked post by woods223 On thread : Sighting in your hunting rifle

    PBR, MRD as in StrelokPro, maximum rise or fall from line of sight. All the same thing, system has been used successfully for years. Other people use drop charts/rangefinders for ranges past 300...

    Liked On: 06-11-2023, 04:15 PM

13. 
    zimmer liked post by Vanman On thread : 4895 vs 2206h

    Having done a bit of digging into light loads recently, with Hodgdon suggesting that H4895 can be used for 60% of max loads, that would seem to be the critical area where they might not be...

    Liked On: 06-11-2023, 04:10 PM

14. 
    zimmer liked post by Micky Duck On thread : Sighting in your hunting rifle

    If your line of sight IS perfectly horizontal your bullet gains altitude by 2-4" on way to its trajectory peak.....is that better???ffs

    Liked On: 06-11-2023, 11:45 AM

15. 
    zimmer liked post by grandpamac On thread : Sighting in your hunting rifle

    And this is why all new firearms users should be encouraged to join a relevant club and get first hand knowledge rather than some of the BS from the internet. There is a lot of good stuff on the...

    Liked On: 06-11-2023, 09:52 AM

Page 7 of 100 First 12345678910111213141516171819202157 ... Last

• Jump to page: