A light crimp is fine just need to roll it in a little so it is flush with the front of the groove so it won't catch when chambering
just run a finger over it you will feel it, don't crimp to much...
Type: Posts; User: shooternz
A light crimp is fine just need to roll it in a little so it is flush with the front of the groove so it won't catch when chambering
just run a finger over it you will feel it, don't crimp to much...
Only tried a few loads with AP 70 don't have enough to do serious load development with it but 7.0 grains went well
velocity was in the 900fps range,
For full power loads I use 2400, Some of my...
As soon as some turn up grab them people will turn American and start hoarding components this time round nothing will stay on the shelves long
Going to try that in the .44 mag when out of lockdown, I use it in .38 .357mag and .45 ACP pistols
it is in the Red Dot Bullseye AS30 class powders so should be good velocity wise
Look up loads...
Didn't say the velocity was 1000 fps, Just said it was slow, I was looking for the lowest load for Traill Boss in the .44 mag 6.0 grains would be it,
And you are correct Traill Boss is not the best...
Lyman still make the 330 grain HP Gould mold but it is a pain the arse it is only a single cavity, to hard to do a pile of bullets one at in time
hard a 54 cal HB Minnie mold never again, If I had...
Yes they expand; they are very soft from feedback from people that use them they don't exit pigs where the 280 FP does
The only outfit that makes the 45 HP mold I want has gone missing may have go for a heavier HP than I wanted,
I think a 30/30 will come first getting more requests for that than the .45 sorry...
[QUOTE=Bill999;1211780]30cal subs are considerably more quiet than 44cal subs but the 44 is quite a bit more quiet than 450bm so I quite like the 44 as a good compromise that still puts big holes in...
Yes the 35 cal is an excellent choice people seem to forget that in the Black powder era bullet diameter was important as velocity was only 1500fps or less
The .35 cal was used as a small game...
This is the one aso a 250 grain available
176789
Not planing on sub use, not much point high B.C's are no benefit at 1000fps and the range is limited to 100 metres,
And .44's are not quiet well mine isn't Loaded 6 grains of Traill Boss with the...
This is my setup haven't settled on a sight yet just using what I have, It is basically a test rig use a Leupold 12X most of the time
the scope in the picture is one I bough off Graham Champion, ...
Don't worry about fillers not needed in the .44 Mag with any of the shot gun powders, Look up loads for the .44 Special for start loads
I have gone down to 6 grains of Trail Boss with the 270 HP...