Welcome guest, is this your first visit? Create Account now to join.
  • Login:

Welcome to the NZ Hunting and Shooting Forums.

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed.

Search Forums

Advanced Search
DPT Terminator


Search:

Type: Posts; User: gundoc

Search: Search took 0.01 seconds.

  1. 19-08-2019, 10:39 PM

    Thread: Engineering design book suggestions

    by gundoc
    Replies
    17
    Views
    1,914

    A few points to consider: Any load-bearing...

    A few points to consider: Any load-bearing recessed corners should always have a radius rather than a sharp corner to reduce the possibility of stress cracks. Good steels and alloys don't cost much...
Results 1 to 1 of 1
Welcome to NZ Hunting and Shooting Forums! We see you're new here, or arn't logged in. Create an account, and Login for full access including our FREE BUY and SELL section Register NOW!!
All times are GMT +13. The time now is 05:34 AM.