Ok - so did some poking around today
The gas HW cylinder (old) is fed by a NEFA PR v/v, (been fitted where the header used to be)
Can this be cranked up a little?
I cant find where the mains...
Type: Posts; User: Spanners
Ok - so did some poking around today
The gas HW cylinder (old) is fed by a NEFA PR v/v, (been fitted where the header used to be)
Can this be cranked up a little?
I cant find where the mains...
Pnuepress with a pump yes
We run small units on the ship to boost pressure to areas too far away from the main CW system
Wouldnt be very big due to where it would be fitted and the damn things are...
7716
This is tank height. As you can see not a lot of drop
Need to find out
Did think about putting a small pneupress tank in
We're currently on gas hw, and will be pulling it and putting an infinity in, all walls will be out so if anything needs to be done,trying to plan ahead now
Want decent pressure :omg:
Checked the pressure through the arvo and tonight - no change
Checked the toby was fully open - it was, noticed there was a new one fitted (been 2 yrs since we lived here - so done in that time -...
Built in 1970
There is a ring main in the street it appears from council drawings and each house comes off that.
Thinking the lack of head pressure from the tank is main reason?
We've had 2 days rain in 3 months here!
We're on top of the hill and the tank isn't much higher in elevation.
Must watch neighbours hose next time they are using it and see if theirs is shit too. ...
So outside at mains pressure as per the CW system, or is the internal CW reduced?
Trying to chase down low pressure, on the whole in and out system, but starting to wonder now if the mains is just...
Would it be safe to say that your tap for the hose on the side or your house is generally mains pressure, and not reduced as could be the cause with internal plumbing?