Search:

Agreed. They are there purely for a look to carry on the 'lines'. They offer no measurable weight reduction. I'll likley scrap them, purely because of controversy. Easy to delete of a cnc program. ...

PM me about how much weight you got off there mate. I'm about to model up my mini and model in some cuts. Will flute the bolt too. Have already threaded the bolt.

Way ahead of you mate.
Been designing them already. Getting them to look "nice" is a bit tricky, but will get there. Then heaps of variables like scope widths heights ect. About to tackle those...

Possibly, but not over the thread/tenon area. So makes it a little pointless I'd think.
I've modeled up some direct ring mounts and they are somewhere in the line of projects.

Just send me a pm mate and can be sorted!

Took 80grams off. With a replacement bolt handle and bolt fluting it will take off lots more.

Nice Chassis mate!! :) Ill be doing that soon and fluting the bolts.

Only 0.5mm deep there. But I hear your concern. Very easy to remove those cuts from the program. Ill do yours like that :)

I did mate.��249390
249391

Barrel will still be factory. At some point a carbon stock.

I've always been into light rifles because I'm lazy and weak. So here's a tikka I recently has my way with.

I like it, but forgot to weigh it before....249332
249333

I've put a far amount of time into getting theses where I think they are good to go.
No more dropping factory mags accidentally. The release is built to be enclosed and protected. It also is...

I've been messing about getting my set ups down for doing bolt fluting. Here's a sample of two options.
I'm a fan of the fast flute option. Going to try it too with a bull nose cutter vs a ball....

246791
I've been working on a solution to the mini bottom metal issue.
About ready

seen it heaps of times

I wonder if a takedown conflicts with the same regulations? Haven't looked at it too hard. Be an interesting thing to argue that when the barrels not attached it's not a rifle. Guess hardy does it...

It's on the list of things to design...

easy to reduce a bolt face diameter too....

Clive Judd of Precision Platforms does a real nice stock

For all those with chassis and those that want them.
Have the bag riders done up. Come in at 30grams with the need cap screw. $60+post245272

244801

Got a decent one

239759
You're all bad people, look what you made me do!

Refreshing this thread as it's that time of year again. I'm super keen to try this topwater jazz for kingies.
I've got a boat (3.5m smart wave). It a bit small but thays the budget. I havent tried...

https://www.bunnings.co.nz/bahco-wrecking-knife_p046724

everyone tried to help ya

Yep heard that too. Was out last night, heaps of kahawai. Made for a fun evening. Water isn't warm enough yet I think. But not sure. Very new to that