Thread: .338 bullet pulling die

Long shot but does anybody around the wellington region have a .338 cal bullet pulling die? need to pull x 50 edge rounds, some beers and/or a wristy payment

Just a hammer type puller would work wouldn’t it
I just do 10 at a time if I have alot to do

What did you do to get 50 rounds that need pulling lol

Hammer is a nightmare haha. Rebarreling a rifle to a different cal

Vice grips and the press will work, obviously buggers the projectile for re-use though.

Originally Posted by Moutere

Vice grips and the press will work, obviously buggers the projectile for re-use though.

Wonder if it'll leave them in tact with some soft jaws like O state aluminium or plastic tightened to the minimum required?

Edit: Or if you're willing to sacrifice one piece of fired brass use that to slip over the bullet before clamping with the vice grips.

Iv got a press mounted puller here with a .338 collet. Can post it up if you cant find anything closer?

Genius.
I've been looking for an excuse to buy a set of soft jaw Knipex

Originally Posted by Nibblet

Wonder if it'll leave them in tact with some soft jaws like O state aluminium or plastic tightened to the minimum required?

Edit: Or if you're willing to sacrifice one piece of fired brass use that to slip over the bullet before clamping with the vice grips.

Originally Posted by Moutere

Genius.
I've been looking for an excuse to buy a set of soft jaw Knipex

Attachment 84635

Yeah those are great for connectors etc. Or oil filters

I would recommend the ones with the pin that holds the rubber insert through the side though as the ones with a screw through the face of the pad will fuck things once they wear down a little.

Send them to me, easy as