Thread: Projectile performance

https://www.jaycar.co.nz/20-piece-mi...1-6mm/p/TD2406

Is this any advantage? Go up in gradations or go straight to 0.08mm? Do I need a needle drill or pin vise? Have ordered a pin vise.

Originally Posted by TeRei

https://www.jaycar.co.nz/20-piece-mi...1-6mm/p/TD2406

Is this any advantage? Go up in gradations or go straight to 0.08mm? Do I need a needle drill or pin vise? Have ordered a pin vise.

I had to google pin vise but it appears needle drill and pin vise are the same thing.
I just use the 0.8mm bit, dont step up in increments. All you're doing is clearing any of the jacket thats folded over to make sure the tip is open. I just go until I touch the lead core.

Thanks. Meant going up to 0.08mm.Just picked up the drills from Jaycar. Man 0.08mm is small. Awaiting the Tamiya pin vise. Jaycar jaw did not accomodate that size..under 1mm.Getting email off to Kaikohe to order some 95gr Targex. My shooter is arriving later today so overcome my horror run this morning. Fattys running away into the scrub.