Thread: Stuck case stuck goodly.

Originally Posted by Cordite

@Snowgrass

With that screw jammed in the expander ball has to be high up in the resizing die.

Mechanically, if the expander ball is too far up, that is, up in the neck area of the die, then the brass is truly jammed in between.

Are you able to remove the jammed in screw and then tap the stem of the expander ball to make it sit low in the case? The decapping pin should be visible through the drilled out primer hole then.

With the screw in, the expander still had room to move. Pulled the decapping pin out with the stem so had no issues there. She’s out now and all good.