Thread: Substituting projectiles

Originally Posted by PeteD

I must admit I had neglected to neck size rounds I have done this to.
Am I correct in thinking that if I was to remove the deprimer in a standard lee die then it would only neck size?

No. You have t back the die out until it jsut engages the neck fo the casee, not the shoulder. Wind the die out a bit, and make a mark on a case with a felt tip, (or just put some lube on the neck) and run it into the die, you should be able to see where the die has sized part of teh neck a bit. Lower it until you are sizing the whole neck, but not more.
You can keep the expander and decapping pin in, normally, to deprime the case, but this guys purpses he wants to neck size cases that are already primed, so he needs to take it out.