Thread: Noise Sharing Devices.

Originally Posted by Rushy

Jeez GM ya wipe glue all over the threaded part, whack the fucker on the barrel and screw it round and round til it gets to the end of the thread then you put a screw driver at right angles through one of the holes in the side of the brake, put your knee on the rifle and twist the screwdriver as hard as ya can to nip it up. I would also recommend then drilling a few holes through the brake into the barrel and whacking in a few rivets. If you are worried about it after that then a hunk of duct tape will finish the job. If when shooting the rifle, the barrel jumps straight upwards then you have fucked the install up by ninety degrees but rather than undo it all you can just lay the rifle over on its side. Ha ha ha ha.

Sideways sounds a bit gangsta' Rushy. But then you have met TR.