If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed.
As above if you have got it early and its just a few spots no dramas to spot weld them.....if its wide spread depending on the size of the hull it would be more economic to rehull from the chine down.
Without knowing anything about your boat other than its a Fryan...
If it has a removable ply/alloy deck and Styrofoam under it remove it all and give the inside of the hull a high pressure fresh water blast then take it to someone to inspect and quote.
If it has sealed alloy chambers things could complicate but same applies. ...remove underfloor tanks etc and anything you can to access and water blast inside of hull for inspection and quote/estimate.
Otherwise you are just paying big charge out rates to basicly clean up shit that you can do yourself so the contractor can estimate/advise accurately.
Removable ply deck,mid 80s 4.6m deep v shape Fyran family series,removed styrofoam years ago,owned her for close to 25 yrs now.
Welcome to NZ Hunting and Shooting Forums! We see you're new here, or arn't logged in. Create an account, and Login for full access including our FREE BUY and SELL section Register NOW!!
Bookmarks