so fryan dingy has warning label on it not to use steel fittings etc etc etc to stop reaction (galvanic??) its electrolisis or fancy name for rust of non iron type metals...if you put a say 4" nail on bottom of alloy boat,the reaction between the two metals can see the nail eat its way through hull
which begs question has your boat been in salty near Kawhia and picked up iron sand.....
would this be enough to cause issues????
MS2 will gum up holes short term but if hull is that far gone....would you trust it???
had this issue with fryan we bought...fortunately we spotted issue straight away and Mr Boats was good enough to take it back for full refund with apolagy,we privately bought another and have kept it out of salt water and are reasonably careful to keep it clean and free of metal stuff.
Bookmarks