If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed.
Hi R 93, The way I did it is I had already made up the barrel breach plug with the octagonal machined on it, so after fitting in the breach plug I set up the breach end in the 4 jaw chuck other end in the turning center. the pic shows the barrel and cutter, but I cut only half of the flat at a time, it was to hard to do it all at once. So the plug was my divider for cutting the octagonal and just used the hand wheel on the saddle for up and down, nice and slowly, fine cut. Homebrew.357
PS, The bike parts and gearbox in pic #206 are for cutting the rifling in the barrel.
Awesome. You must be patient.
When I seen the sprocket I immediately thought dividing head but did wonder how you measured it for a cut.
Hard case either way.
Welcome to NZ Hunting and Shooting Forums! We see you're new here, or arn't logged in. Create an account, and Login for full access including our FREE BUY and SELL section Register NOW!!
Bookmarks