Thread: Makeing a double paper patch mould

I thought it was Gadgetman who had the new old lathe, give him something to do. Now Maca49, don`t rush me, all will be revealed. First off is the stuff ups, , yes I do make them, the d bit left a taper in the bullet mould, so a small boring cutter was used to straighten them out. One of them I used a rubber verier gage and went in a bit to far, but it`s ok, just a bit heaver . The next job was milling the slots for the handles , yep you guest it , on my lathe , then drilled two pin holes to holed the handles on, two screws to holed the pins in and fit the spruce cutter, it`s good to go. I will not know what I`v got till I do a bit of casting, can't stand the suspense ! , Homebrew.357.
, The "D" bit.
, Milling handle slots.
, drilling pin holes.
, Two screws to hold them in.