30.06king
Member

622 Likes

Page 6 of 42 First 1234567891011121314151617181920 ... Last

• Jump to page:

1. 
   shananah liked post by 30.06king On thread : Safest Method Of Discharging Unknown Primers?

   Run the cases through your die and push them out. Wear safety gear, just in case. I've done hundreds without a single mishap. Most I keep asisde for reuse in fouling loads and evcery one has ignited.

   Liked On: 30-03-2024, 11:08 AM

2. 
   outlander liked post by 30.06king On thread : Safest Method Of Discharging Unknown Primers?

   Run the cases through your die and push them out. Wear safety gear, just in case. I've done hundreds without a single mishap. Most I keep asisde for reuse in fouling loads and evcery one has ignited.

   Liked On: 30-03-2024, 10:01 AM

3. 
   dannyb liked post by 30.06king On thread : Safest Method Of Discharging Unknown Primers?

   Run the cases through your die and push them out. Wear safety gear, just in case. I've done hundreds without a single mishap. Most I keep asisde for reuse in fouling loads and evcery one has ignited.

   Liked On: 30-03-2024, 05:09 AM

4. 
   Micky Duck liked post by 30.06king On thread : Guns blown, persons damaged- powder misadventures- examples

   Possibly not a dangerous event but certainly educational to a novice shooter at the time - me ! When I bought my first .270W ( lovely Sako AV ) I proudly showed it to a senior hunting mate / mentor....

   Liked On: 29-03-2024, 06:29 PM

5. 
   Jhon liked post by 30.06king On thread : Guns blown, persons damaged- powder misadventures- examples

   Possibly not a dangerous event but certainly educational to a novice shooter at the time - me ! When I bought my first .270W ( lovely Sako AV ) I proudly showed it to a senior hunting mate / mentor....

   Liked On: 29-03-2024, 06:14 PM

6. 
   Micky Duck liked post by 30.06king On thread : BAD FLYER 9"

   Trout Possibly plastic tip of bullet going AWOL sometime between getting chambered and landing on target. But, even so, 9 inches of movement is a lot. Another possibility is maybe Hornady putting...

   Liked On: 24-03-2024, 03:09 PM

7. 
   Trout liked post by 30.06king On thread : BAD FLYER 9"

   Trout Possibly plastic tip of bullet going AWOL sometime between getting chambered and landing on target. But, even so, 9 inches of movement is a lot. Another possibility is maybe Hornady putting...

   Liked On: 24-03-2024, 02:11 PM

8. 
   AdamAnt liked post by 30.06king On thread : Ruger Walkabout

   After waiting all week finally got a fine (ish ) morning to take the little Ruger .243W out on a walk looking for Rabbits and Hares. Left home a bit later than I wanted to but it was a blustery and...

   Liked On: 24-03-2024, 07:09 AM

9. 
   AdamAnt liked post by 30.06king On thread : Ruger Walkabout

   This is the current load: https://i.postimg.cc/QMhGXHYW/20220908-135712.jpg (https://postimg.cc/BjYwpQ0q)upload a picture (https://postimages.org/)

   Liked On: 24-03-2024, 07:09 AM

10. 
    AdamAnt liked post by 30.06king On thread : Ruger Walkabout

    Out again yesterday morning, early. Warm and humid but, again, blustery. Surprised I saw no Rabbits at all despite evidence they'd been active overnight. Kept walking over the back and peeking over...

    Liked On: 24-03-2024, 07:08 AM

11. 
    AdamAnt liked post by 30.06king On thread : Ruger Walkabout

    The forecast for 01 November looked good and a quick txt to the farmer got me permission to arrive early and walk the farm. Low cloud and very slight drizzle during the drive there in darkness looked...

    Liked On: 24-03-2024, 07:08 AM

12. 
    AdamAnt liked post by 30.06king On thread : Ruger Walkabout

    I hadn't had the Ruger out since early November and was feeling the need. Got permission for this morning, blustery, mercifully cool and overcast. Wasn't sure of what I would find and wasn't overly...

    Liked On: 24-03-2024, 07:08 AM

13. 
    Bagheera liked post by 30.06king On thread : What could cause this?

    Wouldn't hurt to check your scopes are mounted so the horizontal crosshairs are dead level relative to the bore. Being out a little can cause shots to land a bit to the side of vertical on target (...

    Liked On: 23-03-2024, 02:53 PM

14. 
    grandpamac liked post by 30.06king On thread : Old Data and Load Variations. Traps for New Handloaders

    Once I have worked up to a load I like and want to keep with whatever batch of powder I've used I try to buy a few containers of the very same batch / lot of the same powder. Saves the reverification...

    Liked On: 22-03-2024, 06:38 PM

15. 
    JBNZ liked post by 30.06king On thread : What could cause this?

    Wouldn't hurt to check your scopes are mounted so the horizontal crosshairs are dead level relative to the bore. Being out a little can cause shots to land a bit to the side of vertical on target (...

    Liked On: 22-03-2024, 05:26 PM

Page 6 of 42 First 1234567891011121314151617181920 ... Last

• Jump to page: