338MAN mk2
Member

44 Likes

Page 1 of 3 123 Last

• Jump to page:

1. 
   Micky Duck liked post by 338MAN mk2 On thread : A Black powder Roar

   Old stuff that brakes down and is unreliable is way cooler than a piece of European engineering deer slaying artistry. Well done

   Liked On: 18-04-2024, 10:24 PM

2. 
   STC liked post by 338MAN mk2 On thread : Blown suppressor baffle - Launched 20m downrange

   245249 If there is going to be a big sooky cry over this suppressor i will sell the OP my 1st baffle from my goat gun at a discounted price. 3500-4000 shots so just run in. DPT suggested i used...

   Liked On: 05-03-2024, 10:12 PM

3. 
   Micky Duck liked post by 338MAN mk2 On thread : +p ammo

   The reloading manuals have the numbers you're looking for. I load 48grs of 2207 behind the 350s for 1950fps, plenty of smack for me and 6grs less than book max. Plenty of room for a +P load above...

   Liked On: 17-02-2024, 02:34 PM

4. 
   Micky Duck liked post by 338MAN mk2 On thread : +p ammo

   Im new to the 45/70 but love it. I dont think the +P loads are necessary but each to their own. They will kick a bit. Lastnight i was shooting a gong out at 200yds with the 350gr Hornady RN @...

   Liked On: 17-02-2024, 02:33 PM

5. 
   A330driver liked post by 338MAN mk2 On thread : +p ammo

   The reloading manuals have the numbers you're looking for. I load 48grs of 2207 behind the 350s for 1950fps, plenty of smack for me and 6grs less than book max. Plenty of room for a +P load above...

   Liked On: 17-02-2024, 11:59 AM

6. 
   A330driver liked post by 338MAN mk2 On thread : +p ammo

   Im new to the 45/70 but love it. I dont think the +P loads are necessary but each to their own. They will kick a bit. Lastnight i was shooting a gong out at 200yds with the 350gr Hornady RN @...

   Liked On: 17-02-2024, 11:13 AM

7. 
   Longrun liked post by 338MAN mk2 On thread : load data: 3006 / Superformance / 178 ELDX

   Sounds like you have enuf 2209 to load around 400 rounds ! Thats plenty. 57 grs behind any 178-180gr non mono bullet and you are sorted.

   Liked On: 26-01-2024, 06:03 PM

8. 
   308 liked post by 338MAN mk2 On thread : Reloading for 338federal

   Another good super load bullet is the 160gr TTSX. With the subs i tried 315gr soft cast. While they didn't group too well they were acceptable but poi too sideways from super load. The 300gr sierra...

   Liked On: 02-01-2024, 10:56 PM

9. 
   Micky Duck liked post by 338MAN mk2 On thread : Reloading for 338federal

   Another good super load bullet is the 160gr TTSX. With the subs i tried 315gr soft cast. While they didn't group too well they were acceptable but poi too sideways from super load. The 300gr sierra...

   Liked On: 01-01-2024, 09:23 PM

10. 
    Larskramer liked post by 338MAN mk2 On thread : Reloading for 338federal

    45gr of AR2219 behind the 180gr Accu-bond is my favorite load. 2600fps from 17" barrel.

    Liked On: 01-01-2024, 02:52 PM

11. 
    tetawa liked post by 338MAN mk2 On thread : 10-Ring

    RIP mate, and may the stags be closer and the hills flatter where you are now

    Liked On: 11-11-2023, 09:46 AM

12. 
    Shamus_ liked post by 338MAN mk2 On thread : 10-Ring

    RIP mate, and may the stags be closer and the hills flatter where you are now

    Liked On: 11-11-2023, 08:47 AM

13. 
    zimmer liked post by 338MAN mk2 On thread : 10-Ring

    RIP mate, and may the stags be closer and the hills flatter where you are now

    Liked On: 10-11-2023, 03:55 PM

14. 
    JBNZ liked post by 338MAN mk2 On thread : Which rings for tikka & vx5 2-10

    I run vx5 3-15 x 44 and found Talley Ex-Low perfect. Product no 720714

    Liked On: 25-08-2023, 09:06 PM

15. 
    will.i.em liked post by 338MAN mk2 On thread : Hunting rifles and ammo to hire?

    Im embarrassed our fellow shooters aren't more friendly to your request. Probably coz of the current government and their bullshit ( stick the knife in at all cost policies ) I got my start...

    Liked On: 09-07-2023, 08:38 PM

Page 1 of 3 123 Last

• Jump to page: