Very pleasant shoot last night on one of our team sites near Christchurch, with alan and gadgetman from this site. Wandered the big paddocks in the 80 series Cruiser with maxtochs and thermal....
Liked On: 28-01-2024, 07:58 AM
Was rather funny , although the wife was crying absolutely petrified she was up on the kitchen bench,both cats had it bailed up under a wicker basket just a case of sliding barrel in to eight inches...
Liked On: 28-01-2024, 07:55 AM
Jesus christ. Hes clearly stating he doesnt trust it so he hunts with nothing in the chamber, did you even read the full post before going off on a tangent?
Liked On: 23-01-2024, 02:50 PM
If you’re only intending to shoot 300ish meters then don’t worry too much about ES or SD numbers - a 130gr sst doing 3000fps vs 2900fps only has a touch over an inch difference in drop at 300m. Even...
Liked On: 22-01-2024, 11:44 AM
And given he drinks Waikato it's a low bar
Liked On: 19-01-2024, 04:57 PM
.303 was shot on the Saturday prior as an additional match. Mike won that as well. Those are my dots on his target, it is an interpretation but none the less he held good waterline. You only have so...
Liked On: 17-01-2024, 04:37 PM
6.5PRC is more than capable at the distances you mention but with a lot less recoil
Liked On: 16-01-2024, 03:48 PM
If I was you and only because you are running factory ammo stay with the .270 or Creedmoor or 7-08 the 300 mag and PRC are a massive jump in horse power. I've just sold my 7prc and are sticking with...
Liked On: 16-01-2024, 03:47 PM
Was she Dianne Blaymire before she married?
Liked On: 14-01-2024, 09:37 PM
Might want Sika, Sambar, Rusa :P
Liked On: 14-01-2024, 12:00 PM
Well if I've ever seen a damn near perfect waterline. Hats off to Mike for excellent prep, load development and marksmanship
Liked On: 14-01-2024, 06:50 AM
V is near 1 moa and X is half moa.
Liked On: 14-01-2024, 06:50 AM
I have had a borescope for a few years. I do agree what you see sometimes needs interpretation. In saying that I have rifles with new barrels and one can see machining marks in them. Looking at a new...
Liked On: 13-01-2024, 08:56 PM
Seen many a barrel. Looks like rust to me too.
Liked On: 13-01-2024, 08:55 PM
Nice work on the bench & cupboards. My presses are mounted on aluminium plates, 160 x 140 x 6mm. I have captive nuts fixed to the underside of the bench. It takes less than a minute to change or...
Liked On: 31-12-2023, 06:40 AM