ChrisW
Member

817 Likes

Page 5 of 55 First 12345678910111213141516171819 ... Last

• Jump to page:

1. 
   andyanimal31 liked post by ChrisW On thread : Rifle choice: $1600 budget

   I would choose a Tikka

   Liked On: 27-09-2022, 09:23 PM

2. 
   shift14 liked post by ChrisW On thread : Rifle and Optics Snobs

   This thread has made me realise that I have some deep down unconscious snobbery and bias and that I need to recognize my privilege and work on decolonising my gear.

   Liked On: 21-09-2022, 04:37 PM

3. 
   imaca liked post by ChrisW On thread : Rifle and Optics Snobs

   This thread has made me realise that I have some deep down unconscious snobbery and bias and that I need to recognize my privilege and work on decolonising my gear.

   Liked On: 21-09-2022, 04:10 PM

4. 
   dannyb liked post by ChrisW On thread : Rifle and Optics Snobs

   This thread has made me realise that I have some deep down unconscious snobbery and bias and that I need to recognize my privilege and work on decolonising my gear.

   Liked On: 21-09-2022, 01:34 PM

5. 
   mikee liked post by ChrisW On thread : Rifle and Optics Snobs

   This thread has made me realise that I have some deep down unconscious snobbery and bias and that I need to recognize my privilege and work on decolonising my gear.

   Liked On: 21-09-2022, 12:35 PM

6. 
   hotsoup liked post by ChrisW On thread : Rifle and Optics Snobs

   This thread has made me realise that I have some deep down unconscious snobbery and bias and that I need to recognize my privilege and work on decolonising my gear.

   Liked On: 21-09-2022, 12:01 PM

7. 
   bumblefoot liked post by ChrisW On thread : Rifle and Optics Snobs

   This thread has made me realise that I have some deep down unconscious snobbery and bias and that I need to recognize my privilege and work on decolonising my gear.

   Liked On: 21-09-2022, 11:05 AM

8. 
   Kelton liked post by ChrisW On thread : Sako 100

   ^Caliber change requires a whole new bolt. Bolt face is not interchangeable.

   Liked On: 13-09-2022, 09:04 PM

9. 
   Micky Duck liked post by ChrisW On thread : Cleaning plastic/synthetic stocks

   Also a bit of silicone spray (eg crc 808) will be good on plastics to "restore" it a little.

   Liked On: 22-08-2022, 08:58 PM

10. 
    Southcity liked post by ChrisW On thread : Walnut and blued steel,

    Marty Henry here is the other side. 125225 125226 Here is a right hand side shot of it looking at it from the alternate extreme angle. Its like a tiger eye gem in that is changes with the...

    Liked On: 29-07-2022, 04:45 PM

11. 
    Southcity liked post by ChrisW On thread : Walnut and blued steel,

    I hope you dont mind, but here are some more photos of the sako .22 With such a nice piece of wood and a factory finish being what it is, I decided to refine it a little bit. I applied a few coats...

    Liked On: 29-07-2022, 04:44 PM

12. 
    Micky Duck liked post by ChrisW On thread : Big bore Red dot and recoil

    Iv seen low quality red dots not hold zero on a .22 And iv seen high quality red dots purposely be thrown on concrete and hold zero. If its a genuine Aimpoint or similar you are having issues with...

    Liked On: 08-07-2022, 08:44 PM

13. 
    Tedz50 liked post by ChrisW On thread : Big bore Red dot and recoil

    Iv seen low quality red dots not hold zero on a .22 And iv seen high quality red dots purposely be thrown on concrete and hold zero. If its a genuine Aimpoint or similar you are having issues with...

    Liked On: 07-07-2022, 04:12 PM

14. 
    veitnamcam liked post by ChrisW On thread : Burn rate / velocity / pressure / accuracy

    You will have to do load development again. I would start with the same COAL that worked with the other powder and go from there. You could try to aim for a similar velocity and see if it works out,...

    Liked On: 01-07-2022, 08:49 PM

15. 
    dannyb liked post by ChrisW On thread : Burn rate / velocity / pressure / accuracy

    You will have to do load development again. I would start with the same COAL that worked with the other powder and go from there. You could try to aim for a similar velocity and see if it works out,...

    Liked On: 01-07-2022, 11:29 AM

Page 5 of 55 First 12345678910111213141516171819 ... Last

• Jump to page: