Yes, you can do the job your self. Just remove the end cap and weld (or braze) on a piece of 3/16" (4.8mm) steel rod that will go down inside the spring and restrict the travel of the follower. ...
Liked On: 18-11-2019, 01:44 PM
357 magnum has lot better trajectory than 22LR. 140 grain at 2000+fps zeroed to 100 yards has only 4" drop at 150 yards. Its a legitimate 150 yards gun if you have the right load( keeping in mind 2-4...
Liked On: 17-11-2019, 04:59 PM
I have been thinking about getting a dealer licence over here and shipping some nice guns back once in a while.Registration coupled with the potential of an annual fee is going to reduce the number...
Liked On: 17-11-2019, 03:16 PM
You will also have to open up your bolt face but you probably already know that. Might be cheaper in the long run to sell the 7mm08 and buy a different rifle in a caliber that you really want. Just a...
Liked On: 17-11-2019, 03:13 PM
Wrong or right mikee.....the shit-pie that’s being handed down makes it difficult for many who are spending good money to stay within the confines of these bullshit laws
Liked On: 15-11-2019, 10:53 AM
Popped into Roxburgh with Dan one evening and I was quite proud to show him the home of Jimmy's pies...he was like "what's Jimmy's pies???" It was one of those moments when you feel like saying...
Liked On: 02-11-2019, 12:59 PM
Another thing to check on an older rifle is the mainspring (firing pin spring) as old springs can get soft and cause inconsistent ignition which will give fliers. Happens occasionally on a new rifle...
Liked On: 01-11-2019, 10:26 AM
Soldering iron tip held on the top of the screw head just long enough to heat the length of the screw can loosen the glue/loctite.... good luck
Liked On: 31-10-2019, 10:59 AM
csmiffy the 90gr TNT was a hoot but have shot the most game with the 140sst. My rifle shoots the 147 and 143 Hornadys well so will try them soon
Liked On: 29-10-2019, 09:14 AM
PM me your address if these suit? 122785
Liked On: 27-10-2019, 03:52 PM
Shoot here a few weeks ago had a nice haul.top to bottom PH safari 3006, large ring huski 9.3x57, small ring huski 9.3x62, obendorf mauser 9.3x62, the last 2 are the work of Alan Carr
Liked On: 27-10-2019, 03:51 PM
Yup - I've been working on a similar project - but still in 303, just downloaded a bit, a 125gn at 2500-2600 with 30 gns of powder (I've found this amount suppresses really well). Still with a...
Liked On: 21-10-2019, 01:12 PM
try again 122423
Liked On: 20-10-2019, 02:12 PM
Pretty sure that barrel is friar tucked smiffy. If I had more money than sense I was going to make a 350rem mag or 308norma out of it
Liked On: 11-10-2019, 08:24 PM
Did that a few years back on a Harley ( When in Rome...) I have NO clue how Americans call it the "World's Greatest MC Ride". Boring as compared to many NZ rides. Guess it just shows how poorly...
Liked On: 08-10-2019, 07:07 PM