Delphus
Member

135 Likes

Page 2 of 9 First 123456789 Last

• Jump to page:

1. 
   Delphus liked post by 7mmsaum On thread : Santa Fe heater issue

   Check the “door” or gate that allows hot air to enter that side The stainless pin will be sliding inside the door and not moving it Or the clip has fallen off the actuating cable Keep...

   Liked On: 04-06-2023, 02:49 PM

2. 
   Delphus liked post by tibo On thread : Carbon fibre/epoxy gurus help please

   Has it been exposed to elevated temp like in the ca in summer or even outside under the sun? standard epoxy have a transition glass temperature arround 60-70deg which is the temp at which the epoxy...

   Liked On: 12-05-2023, 10:02 PM

3. 
   Delphus liked post by Tentman On thread : Carbon fibre/epoxy gurus help please

   It could be "blush" - some epoxies are prone to this . . . Basically not cleaning enought between coats

   Liked On: 12-05-2023, 10:01 PM

4. 
   Delphus liked post by tibo On thread : Carbon fibre/epoxy gurus help please

   Amine blush would happen straight away no? This kit you used is all good, I used it heaps. UV stabilise will help with the yellowing but it will still go bad if it goes past TG. Carbon heat really...

   Liked On: 12-05-2023, 10:01 PM

5. 
   Delphus liked post by Scott Cowan On thread : Carbon fibre/epoxy gurus help please

   Yeah, just rough sand and patch over it and re finish. I do all mine in layers now. Gives a free layers in stress areas and tight curves and is easier to get a better finish. I gladwrap and tape...

   Liked On: 12-05-2023, 08:41 PM

6. 
   Delphus liked post by dannyb On thread : Swarro scopes

   take them out at last light and see how they compare side by side to your eyes then keep which ever one performs better to you

   Liked On: 08-04-2023, 09:08 PM

7. 
   Delphus liked post by janleroux On thread : Wellington 200m+

   Hi Ash, You can join us on the Seddon / Trentham range as a guest if you want to shoot 300 - 1000y on electronic targets. If it is your first time, you have to start at 300y (defence range rules)...

   Liked On: 15-01-2023, 03:03 PM

8. 
   Delphus liked post by Frogfeatures On thread : Proud dad moment

   I assume theres a story there ? :D Well done OP and daughter :thumbsup:

   Liked On: 24-09-2022, 09:53 PM

9. 
   Delphus liked post by Micky Duck On thread : Proud dad moment

   interesting you now shoot over the fence.....

   Liked On: 24-09-2022, 09:53 PM

10. 
    Delphus liked post by RUMPY On thread : Proud dad moment

    Excellent job dad and very good shooting from your daughter. Pretty sure I've seen that range before too.

    Liked On: 24-09-2022, 09:53 PM

11. 
    Delphus liked post by Micky Duck On thread : Proud dad moment

    I recognize that bench...... good shooting young lass.

    Liked On: 24-09-2022, 09:53 PM

12. 
    Delphus liked post by shift14 On thread : Proud dad moment

    Fantastic. Lucky girl. B

    Liked On: 24-09-2022, 09:52 PM

13. 
    Delphus liked post by 7mm Rem Mag On thread : Proud dad moment

    Good stuff

    Liked On: 24-09-2022, 09:52 PM

14. 
    Delphus liked post by Tahr On thread : Lighter mid range scope

    GPO Passion 4-12. Imported they are as cheap as chips. A nice little dial-able turret under the caps - they come with a 6.5 CM ballistic replacement dial (amongst other calibers). Good glass. Dial...

    Liked On: 17-08-2022, 10:16 AM

15. 
    Delphus liked post by NZShoota On thread : Ammunition shortage

    Just as an indicator, This from Rivers to Ranges "Ammo update We have just received another top up And have stock of the following ammo 22 Hornet - light 222 - light

    Liked On: 06-08-2022, 06:07 PM

Page 2 of 9 First 123456789 Last

• Jump to page: