Friwi
Member

2311 Likes

Page 7 of 155 First 12345678910111213141516171819202157107 ... Last

• Jump to page:

1. 
   Larskramer liked post by Friwi On thread : What Have You Loaded Today

   I loaded 40 rounds of300 black with 200 gr maker bullet. Just need to go hunting now

   Liked On: 18-02-2024, 09:47 PM

2. 
   tetawa liked post by Friwi On thread : Why does "Sako" run cheap arsed, hard arsed solid rubber butt pads ?

   À lot of those limbsavers pads become sticky after 3 to 5 years anyway and need replacement. Probably not a thing that beretta wants to deal with. They have enough to do with their 3 brands of...

   Liked On: 18-02-2024, 06:13 AM

3. 
   caberslash liked post by Friwi On thread : Remington moving shop to more "gun friendly " state

   And the lips of their junky mags are spreading and jamming the cartridges…. ;-]

   Liked On: 17-02-2024, 10:02 PM

4. 
   Shearer liked post by Friwi On thread : Show me your lightweight rifle

   I recently read a review in a French hunting magazine about the Sabati rover carbon.2.4 kg. It was a very accurate rifle at under €2000 . Which easily compete against the Sako carbon light...

   Liked On: 17-02-2024, 07:38 AM

5. 
   KJL liked post by Friwi On thread : FIORDLAND BOOT ADVICE

   No master what you will get your feet wet. Take a couple of gore tex socks if you can and if you can walk in them.

   Liked On: 16-02-2024, 05:55 PM

6. 
   TakaRat liked post by Friwi On thread : Wairere Fall's Hunting

   There is another clearing further north on the north south track. You have to go through some scrub to find it , it is on the right hand side. I went through it a few times but since I forgot to...

   Liked On: 16-02-2024, 10:38 AM

7. 
   caberslash liked post by Friwi On thread : Is the new 7mm PRC a lemon ?

   The tikka long action mag works very well too :-) not even need to replace the bottom metal or to put it into a chassis …

   Liked On: 16-02-2024, 08:36 AM

8. 
   Ana liked post by Friwi On thread : Seeking Hunting Grounds Advice around Auckland

   Welcome to the forum. I am not in Auckland so I can’t really help. But I m sure someone with raise their hand and help you.

   Liked On: 15-02-2024, 06:44 PM

9. 
   veitnamcam liked post by Friwi On thread : Is the new 7mm PRC a lemon ?

   Funny , I remember the 7mm 162 amax of 2003 that would vaporise in mid air when launched from a 7mm weatherby … Talking about weatherby, with their long freebore, it might be possible to set the 175...

   Liked On: 15-02-2024, 02:54 AM

10. 
    dannyb liked post by Friwi On thread : Is the new 7mm PRC a lemon ?

    Funny , I remember the 7mm 162 amax of 2003 that would vaporise in mid air when launched from a 7mm weatherby … Talking about weatherby, with their long freebore, it might be possible to set the 175...

    Liked On: 14-02-2024, 07:22 PM

11. 
    TakaRat liked post by Friwi On thread : Wairere Fall's Hunting

    I have shots 3 deer overthe years in the clearing you are talking about. They are constantly been checked out by hunters. So any time a new deer pops up it pretty much get shot. You just have to be...

    Liked On: 13-02-2024, 08:17 PM

12. 
    Micky Duck liked post by Friwi On thread : 1000 yard gong

    If you can tie a few 1 meter long rubans to some poles along the way you will learn a bit more about the influence of the wind and when to take the shot .

    Liked On: 12-02-2024, 07:53 PM

13. 
    Nathan F liked post by Friwi On thread : 308 bush pig loads

    The 150 sst never shot well in my kimber :-( all right for stuff within 50 m( I shot a sow at 25m with them) but at 100m it was up to 2.5” group. The 168gr sierra match kings on the other hand are...

    Liked On: 11-02-2024, 07:57 AM

14. 
    caberslash liked post by Friwi On thread : Rem 700 magazine well

    No, that is probably because the spacer has not been put on from the top . There are two tabs on the top which stop it from falling down. But sometime you can still hear the spacer rattling

    Liked On: 11-02-2024, 12:04 AM

15. 
    erniec liked post by Friwi On thread : Rem 700 magazine well

    No, that is probably because the spacer has not been put on from the top . There are two tabs on the top which stop it from falling down. But sometime you can still hear the spacer rattling

    Liked On: 10-02-2024, 09:36 PM

Page 7 of 155 First 12345678910111213141516171819202157107 ... Last

• Jump to page: