Just getting into a bit more chambering for the odd special and research seems to show that many use a floating reamer holder to ensure perfect alignment of the reamer to the barrel blank. After...
Liked On: 13-11-2022, 07:33 PM
Just getting into a bit more chambering for the odd special and research seems to show that many use a floating reamer holder to ensure perfect alignment of the reamer to the barrel blank. After...
Liked On: 13-11-2022, 05:08 PM
So, following on from my post about chambering, I tried out the reamer holder and using off cuts from a recent job made a couple of 12G to 9mm chamber adaptors.
Liked On: 13-11-2022, 02:28 PM
So, following on from my post about chambering, I tried out the reamer holder and using off cuts from a recent job made a couple of 12G to 9mm chamber adaptors.
Liked On: 13-11-2022, 02:05 PM
So, following on from my post about chambering, I tried out the reamer holder and using off cuts from a recent job made a couple of 12G to 9mm chamber adaptors.
Liked On: 13-11-2022, 11:53 AM
So, following on from my post about chambering, I tried out the reamer holder and using off cuts from a recent job made a couple of 12G to 9mm chamber adaptors.
Liked On: 13-11-2022, 11:49 AM
Look at long shot target cameras - 300m to 2 miles … seen them to 1200m and several cameras at once https://owloptics.nz/collections/longshot-target-cameras
Liked On: 23-10-2022, 12:17 PM
Sorry not looking to hijack your thread, just sharing the knowledge. I just remembered that I also made a radius turning jig to cut a nice smooth and consistent rad on the heads.
Liked On: 19-10-2022, 06:47 PM
Seeing you making screws reminded me of aa set-up I made a while back to easily make perfect slots in screws. Basically, you mount a drill chuck in a tool holder and use a slitting saw in the chuck....
Liked On: 19-10-2022, 06:45 PM
Sorry not looking to hijack your thread, just sharing the knowledge. I just remembered that I also made a radius turning jig to cut a nice smooth and consistent rad on the heads.
Liked On: 17-10-2022, 06:45 PM
Sorry not looking to hijack your thread, just sharing the knowledge. I just remembered that I also made a radius turning jig to cut a nice smooth and consistent rad on the heads.
Liked On: 17-10-2022, 06:38 PM
I got another one through today, this little Thompson Centre 10/22 clone. The guy wanted it cut down, re-threaded and the fore sight moved back. Have to say it came out really well and has made...
Liked On: 15-10-2022, 03:42 PM
So just to clear this up I was one of the Gunsmiths involved with the tube mag mods and did over 400 guns and I remember having to modify these Brownings. The test is to remove the inner tube and...
Liked On: 14-10-2022, 08:56 PM
I got another one through today, this little Thompson Centre 10/22 clone. The guy wanted it cut down, re-threaded and the fore sight moved back. Have to say it came out really well and has made...
Liked On: 13-10-2022, 10:42 PM
I got another one through today, this little Thompson Centre 10/22 clone. The guy wanted it cut down, re-threaded and the fore sight moved back. Have to say it came out really well and has made...
Liked On: 13-10-2022, 08:32 PM