Old_School
Member

299 Likes

Page 16 of 20 First ... 234567891011121314151617181920 Last

• Jump to page:

1. 
   Old_School liked post by Micky Duck On thread : mounting scope on a 303 sporter

   an inch at 50 with a SMLE is not good,its friggin GREAT groupings...they were only speced to do 4" or better at hundy from NEW.... dont be a hurry to change things.

   Liked On: 12-04-2023, 09:31 PM

2. 
   Old_School liked post by grandpamac On thread : .303 rifle recoil, sore shoulder

   Greetings, Definitely consider light handloads. Point of impact can vary widely with different sorts of ammo. If you handload I can suggest some lighter loads that I used in my steel butt No4. GPM.

   Liked On: 12-04-2023, 09:27 PM

3. 
   Old_School liked post by Micky Duck On thread : clay trap, correct way to throw doubles?

   it slides outwards and flies off the end

   Liked On: 12-04-2023, 09:24 PM

4. 
   Old_School liked post by Skeetshooter On thread : clay trap, correct way to throw doubles?

   The clip is only there for when the trap is tipped back so far the target would slide down the arm, I doubt sitting a target in front of the clip would do any good, when the trap fires the target...

   Liked On: 12-04-2023, 07:36 PM

5. 
   Old_School liked post by Skeetshooter On thread : clay trap, correct way to throw doubles?

   Do you mean one in front and one behind the teal clip? Cause can't see that working? If you aren't going to throw near vertical targets take the teal clip off, then 2 targets will fit on the blade...

   Liked On: 12-04-2023, 07:34 PM

6. 
   Old_School liked post by Marty Henry On thread : clay trap, correct way to throw doubles?

   Place one target normally and the other at the front of the throwing arm that should work

   Liked On: 12-04-2023, 07:33 PM

7. 
   Old_School liked post by Micky Duck On thread : clay trap, correct way to throw doubles?

   Im pretty sure looking at photo,there is a nut out of site on end of the long bolt on spring...loosen it to reduce the twang/power factor,tighten to increase.

   Liked On: 10-04-2023, 04:10 PM

8. 
   Old_School liked post by zimmer On thread : How often do you clean your rifle?

   There are differing opinions amongst barrel makers re the use of bronze brushes and differing opinions re pulling them back through the muzzle/crown. All I would recommend is if you use bronze...

   Liked On: 10-04-2023, 02:28 PM

9. 
   Old_School liked post by kiwial On thread : How often do you clean your rifle?

   No damage is caused cleaning using a quality one piece rod, bore guide and a bronze brush. Most mass produced barrels don’t like to be taken back to bare steel and can use a couple of shots to...

   Liked On: 10-04-2023, 02:28 PM

10. 
    Old_School liked post by Bol Tackshin On thread : .303 rifle recoil, sore shoulder

    My dad joined the South African Police at 16. Shooting practice with .303 rifles saw him fire a few rounds and have to crawl forward to get back into position, because the recoil had pushed his...

    Liked On: 10-04-2023, 12:19 PM

11. 
    Old_School liked post by Bagheera On thread : .303 rifle recoil, sore shoulder

    Get along to a physiotherapist and check out if you have some “frozen shoulder” before it gets worse. In general , building up beef ( not lard ) with strength training is helpful to shooting but...

    Liked On: 10-04-2023, 12:19 PM

12. 
    Old_School liked post by -BW- On thread : .303 rifle recoil, sore shoulder

    I also have bursitis in my shoulder, and its my opinion that most of your discomfort is coming from that. Perhaps it is causing you to hold the rifle in a way which you normally wouldn't, but if I...

    Liked On: 10-04-2023, 12:18 PM

13. 
    Old_School liked post by grandpamac On thread : mounting scope on a 303 sporter

    Greetings @ Old_School, The base on your rifle is a Parker Hale, or copy, made for your No1 Lee Enfield. The rings are either low or medium Parker Hale or copy. Both are correct for the rifle, Your...

    Liked On: 10-04-2023, 11:59 AM

14. 
    Old_School liked post by zimmer On thread : mounting scope on a 303 sporter

    Had a Pecar in 1967. Bought with the intention of fitting to my 308 Forester. 26mm rings unavailable at that time so got a refund and bought a Weaver K4. Optically a lesser animal but cheaper than...

    Liked On: 10-04-2023, 11:59 AM

15. 
    Old_School liked post by Micky Duck On thread : mounting scope on a 303 sporter

    the scope you using is part of issue...a longer bodied model will allow it to come further back.Im guessing a no name 4x32 from gunshitty etc bought on a 22lr package?? or bought for under hundy$$$...

    Liked On: 05-04-2023, 03:36 PM

Page 16 of 20 First ... 234567891011121314151617181920 Last

• Jump to page: