rewa
Member

3317 Likes

Page 24 of 222 First ... 101112131415161718192021222324252627282930313233343536373874124 ... Last

• Jump to page:

1. 
   rewa liked post by grandpamac On thread : Reloading 6.5x55

   Certainly a great cartridge that gets better the older it gets. It survived the US attempts to emasculate it with wimpy loads and many cartridges that tried to succeed it. GPM.

   Liked On: 21-08-2023, 04:23 PM

2. 
   rewa liked post by Tahr On thread : Reloading 6.5x55

   Three powders have given me 2800 without pressure sighs. R22, imr4831 and n560. I use Norma cases and with the n560 load they are lasting well.

   Liked On: 21-08-2023, 04:22 PM

3. 
   rewa liked post by grandpamac On thread : Reloading 6.5x55

   Greetings All, I did quite a bit on this a few years back which I wrote up in a couple of articles in NZ Guns. The Hodgdons data seemed to fit the powder I had well including my older AR2209 but the...

   Liked On: 21-08-2023, 04:16 PM

4. 
   rewa liked post by Ingrid 51 On thread : Reloading 6.5x55

   And 139 Scenar. I reload using Lapua brass, ADI 2209 powder and Winchester primers (as all I could find at the time)231133

   Liked On: 21-08-2023, 04:15 PM

5. 
   rewa liked post by Ingrid 51 On thread : Reloading 6.5x55

   My Tikka loves both 139 Scenar and 143 eldx. Pic shows eldx @ 100.231132

   Liked On: 21-08-2023, 04:15 PM

6. 
   rewa liked post by grandpamac On thread : Reloading 6.5x55

   That load would be far too hot for any rifle with todays AR2209 which is significantly faster than the pre 2000 stuff. Regards Grandpamac.

   Liked On: 21-08-2023, 04:14 PM

7. 
   rewa liked post by Tahr On thread : Reloading 6.5x55

   Have used mine a bit again recently. A modern Schultz and Larsen. n560 powder and 140 Amax (or gold dot). 21.5" barrel. 2840 fps.

   Liked On: 21-08-2023, 04:14 PM

8. 
   rewa liked post by andyanimal31 On thread : Reloading 6.5x55

   The God of chamberings! On my third factory barrel on my tikka. I have swapped from the 143eldx to the 147eldm. 2720 and is more accurate than I can shoot. Sent from my SM-A226B using Tapatalk

   Liked On: 21-08-2023, 04:13 PM

9. 
   rewa liked post by norsk On thread : Reloading 6.5x55

   It depends on what you are after? As a "bang flop" cartridge I think a 308 has the edge,for flat shooting and mild recoil/little blast the old Swede is hard to beat. I have a couple and have had a...

   Liked On: 21-08-2023, 04:13 PM

10. 
    rewa liked post by mikee On thread : Reloading 6.5x55

    Better performance than a Creedmore, more capacity. Under rated, in a modern rifle with modern barrel they are bloody good (but not trendy)

    Liked On: 21-08-2023, 04:12 PM

11. 
    rewa liked post by rupert On thread : Reloading 6.5x55

    Tikka 595 (22 inch barrel), RL22, 139gr Hornady. Most accurate load around 2750ft/sec.

    Liked On: 21-08-2023, 04:12 PM

12. 
    rewa liked post by Pommy On thread : Reloading 6.5x55

    Same performance as a Creedmoor.

    Liked On: 21-08-2023, 04:11 PM

13. 
    rewa liked post by blair993 On thread : Breaking in the 260rem and load development

    Sing out if you need any brass i have enough now and can spare some.

    Liked On: 21-08-2023, 04:01 PM

14. 
    rewa liked post by Ruapehu On thread : Breaking in the 260rem and load development

    Make sure you haven't or aren't about to run out of windage clicks on your scope,had a bit of drama with my 260 a wee while back with a replacement scope and new rings,was doubting scope but worked...

    Liked On: 21-08-2023, 04:00 PM

15. 
    rewa liked post by grandpamac On thread : Breaking in the 260rem and load development

    Greetings again Sidetrack, You may know the standard test for bedding but just in case here it is. With the action snugged down in the stock hold the barrel and fore end with one hand and loosen the...

    Liked On: 21-08-2023, 03:59 PM

Page 24 of 222 First ... 101112131415161718192021222324252627282930313233343536373874124 ... Last

• Jump to page: