shooternz
Member

911 Likes

Page 9 of 61 First 123456789101112131415161718192021222359 ... Last

• Jump to page:

1. 
   shooternz liked post by Sideshow On thread : 303 vs 308

   https://auctions.holtsauctioneers.com/asp/fullCatalogue.asp?salelot=S0122+++4578C&refno=++168012&saletype= ;):P

   Liked On: 05-12-2021, 01:47 PM

2. 
   shooternz liked post by Marty Henry On thread : Suppressor and load dev

   I think Jhon has the right idea. I feel that for a hunting rifle the idea of developing an ideal load is actually pretty pointless if anything you chuck down the barrel prints about 1 moa anyhow....

   Liked On: 15-11-2021, 01:17 PM

3. 
   shooternz liked post by gundoc On thread : Cartridge suggestions

   .308 or .30/06 will fill your needs nicely with a comprehensive range of projectiles available in the 150 - 180 grain range.

   Liked On: 11-11-2021, 03:22 PM

4. 
   shooternz liked post by Cigar On thread : Crimping 308win subsonics?

   I lightly crimp my subsonics. I use Lyman dies and the seating die can be set to give a roll crimp.

   Liked On: 09-11-2021, 01:07 PM

5. 
   shooternz liked post by WilliamJackson1961 On thread : Screwdriver advice

   Brownell's Magna-Tip pieces are the greatest. These are created in the United States and are of the highest quality available. They have a wider range of sizes than anybody else, and you seldom...

   Liked On: 04-11-2021, 07:44 PM

6. 
   shooternz liked post by ebf On thread : Screwdriver advice

   If you have slotted screws (lever actions...) on the firearms you want to work on, make sure you get a decent set with hollow ground slotted bits.

   Liked On: 04-11-2021, 07:43 PM

7. 
   shooternz liked post by Marty Henry On thread : Ban on using jacketed ammo on steel plates?

   The above should be mitigated by target angle and sand trap if needed.

   Liked On: 04-11-2021, 07:38 PM

8. 
   shooternz liked post by Hayden On thread : Projectile choice 284

   I’m using 150NBTs in my 284. Bang flop. Nut behind the butt is more important IMO

   Liked On: 21-10-2021, 12:56 AM

9. 
   shooternz liked post by Longranger On thread : Shoulder bump question

   ebf I think you will find the custom die is not made from the chamber reamer. I make my own dies from what is called a resize reamer....some 0.004" smaller on critical dimensions. There is no way a...

   Liked On: 18-10-2021, 09:25 PM

10. 
    shooternz liked post by Jhon On thread : Hornady projectiles

    Go to cast bullets.. Rob Walker makes a very decent 6.5mm gas checked flat point good to between 1400-1800 fps in around 1:8 twist or slower. Perfectly good killer out to 100 plus a bit meters. Or...

    Liked On: 17-10-2021, 12:57 PM

11. 
    shooternz liked post by Dermastor On thread : New F Class setup and advice

    PRS can be real gear race but it doesn't need to be. Many shooters who compete start out with reasonably basic rifles and go from there if they continue to compete. If you want to start from scratch...

    Liked On: 11-10-2021, 09:56 AM

12. 
    shooternz liked post by Jhon On thread : 44-40 Reloading/Shooting

    Re reading this thread and I realise shooternz that I mis-understood which bullet you were referring to. Thought you were asking after the Lyman 429-244. Here is picture of the Hawke Targets ...

    Liked On: 25-09-2021, 01:41 PM

13. 
    shooternz liked post by Allizdog On thread : Hunting with subs in 300BLK

    What you don't have in velocity, it's better to make up for in bore size and weight. Unless you can reload specialist projectiles, get a big cal.

    Liked On: 11-09-2021, 07:57 PM

14. 
    shooternz liked post by MB On thread : Hunting with subs in 300BLK

    Another Sub-X fail today. Shot a goat mid-neck at 5 metres. It went down, then got up and ran 50 metres. Huge blood trail, but I was lucky to find it in dense bush. Might as well take up bow hunting!

    Liked On: 11-09-2021, 02:42 PM

15. 
    shooternz liked post by Flyblown On thread : 300blk Loading Tips

    Robert’s 151gr .308 cal shot from a .308 subsonic round @1100fps. Large nanny standing about 25m above me, facing away and browsing on steep ground facing uphill. In behind the ribcage low down,...

    Liked On: 06-09-2021, 09:44 PM

Page 9 of 61 First 123456789101112131415161718192021222359 ... Last

• Jump to page: