I found Trail Boss not very good in my Blackout have had better success with 700X 3,5 grains works ok; any of the powders around the same burn rate would work it doesn't take much to move a cast...
Liked On: 13-11-2022, 08:47 PM
Pity it was made by two dudes that have no firearms knowledge
Liked On: 04-11-2022, 06:10 PM
Try cleaning the threads with alcohol first they get lube all over them, If you only have one expander button then locktite it
Liked On: 30-10-2022, 11:08 PM
It really depends on the powder you use any of the ADI powders don't need Magnum primers But the ball powders general benefit from the extra power, also the primer can can vary some standard primers...
Liked On: 20-10-2022, 11:06 PM
It really depends on the powder you use any of the ADI powders don't need Magnum primers But the ball powders general benefit from the extra power, also the primer can can vary some standard primers...
Liked On: 20-10-2022, 09:03 AM
So that is where all the primers go
Liked On: 17-10-2022, 10:32 AM
So that is where all the primers go
Liked On: 17-10-2022, 08:13 AM
Yes S&B 196 are fine so are the Norma of any weight, at present it is more what you can find than anything else The most common projectiles used in the 8x57 are the heavier ones in the 180 to 200...
Liked On: 07-10-2022, 08:33 PM
The RPA is on par with the Barnard actions great for TR it is what they were designed for a friend of mine shot one for years, The actions were about $1200 to $1600 in the 1990's You can't go...
Liked On: 01-10-2022, 09:44 AM
The Gas Check reinforces the base when using high velocity loads also there is an improvement in accuracy when gas checking a bullet lhat is designed for them, and the bullets can be made from...
Liked On: 29-09-2022, 04:10 PM
The Gas Check reinforces the base when using high velocity loads also there is an improvement in accuracy when gas checking a bullet lhat is designed for them, and the bullets can be made from...
Liked On: 29-09-2022, 02:02 PM
You are correct the reason I bought the 151 HP mould was because it will stabilise in standard .308 twists also it was designed sperficly for the .308 Win if crimped at the crimp groove the Gas...
Liked On: 22-09-2022, 02:02 PM
You are correct the reason I bought the 151 HP mould was because it will stabilise in standard .308 twists also it was designed sperficly for the .308 Win if crimped at the crimp groove the Gas...
Liked On: 21-09-2022, 09:50 PM
i am just getting to do load development with it have been too busy and the weather has been crap, So far it looks good, The rifle is not the regular off the shelf type, Action is a Anschutz 54...
Liked On: 21-09-2022, 04:27 PM
i am just getting to do load development with it have been too busy and the weather has been crap, So far it looks good, The rifle is not the regular off the shelf type, Action is a Anschutz 54...
Liked On: 21-09-2022, 01:32 PM