I loaded some 30-30 with the 160 ftx and 32.5 gr of AR2208. 246518 I then tested them at 100yds aiming at the black square using a rolled up coat for a rest. Good group but left so corrected and...
Liked On: 23-03-2024, 08:05 PM
Sell it, use the $$$ to buy what you want here..cost you more than Pistol is worth just to get it out of the US. Get a quote from a couple of FFL dealers. And that's before you contemplate NZ regs
Liked On: 21-03-2024, 06:11 AM
Flat point /truncated cone, should give you a lot better wound channel than Round nose, yes? What Elmer Keith was all about, right?
Liked On: 18-03-2024, 10:52 PM
can you cast them solid lead
Liked On: 18-03-2024, 06:23 AM
That die does a tidy job
Liked On: 03-03-2024, 09:58 PM
leave them in there..the puke green ones turn them into zombiemax loads LOL.
Liked On: 03-03-2024, 09:57 PM
Loaded up a ladder for the 284. 150 eldx with 2209 and RL17. 245085
Liked On: 03-03-2024, 09:56 PM
Did some 55gr soft points 223 subsonics for myself on my gear and help a couple of mates setup there new reloading gear, show them how too set the dies for 6.5x55 and did some 129gr corelock test...
Liked On: 03-03-2024, 03:39 PM
Some .375 Ruger with Barnes TSX 270 gn loaded today for shooting tomorrow. Load development work. I think a useable load is sorted but have been getting flyers from the third shot in the magazine....
Liked On: 21-02-2024, 09:52 PM
I have no idea of temp, lee pot dropped to 4 setting. I use a ladle not the drippy bottom spout. If it runs like water it's good to go wait till the sprues changed colour then cut and drop onto...
Liked On: 19-02-2024, 08:26 PM
40 rounds of 45/70, 405 cast, beeswax lard mix lube, 60 gr 2f, 40 38/55 cast 285 lead with smokeless, 35 577/450 480 gr cast beeswax lube over 70 gr 2f. Today casting a wodge of replacement...
Liked On: 19-02-2024, 11:06 AM
244057
Liked On: 18-02-2024, 10:32 PM
There is a Thread on another Forum that I frequent that is " What Have You Loaded Today " It is really quite interesting and well participated in . So I thought it might be interesting to see what...
Liked On: 18-02-2024, 10:30 PM
Ive been a fan of Mihec's molds for some years. The quality is unmatched and delivery from Slovenia amazingly quick. Price is irrelevant after a few thousand casts.
Liked On: 15-02-2024, 07:09 PM
I own a few Mp, the brass HP ones are heavy but excellent, the aluminium 8 cavity ones are awesome for casting lots and fast. Sent from my CPH2305 using Tapatalk
Liked On: 15-02-2024, 07:09 PM