Search:

Fingers crossed it holds up this time, it is certainly a nice piece of timber.

I would be interested to see the screw setup as I'm about to build a similar stock and it would be nice not to have...

Very good info as usual.
K95 looking great again, what reinforcement did you end up putting in the new stock?

55gr Zmax, same as a Vmax just a different colour tip

Hoping around the 3400 mark, mainly just wanting to see if the rifle holds together, then will do some load development

Not me, but a mate has loaded them up for the rifle we have been building. 5.6x57, 75gn eld-m with 43gn of 2213 for some test firings. Beside a 223 for comparison
249335

33 WCF? Plenty of .338 proji's available too...

Looking good!
I'm part way through my first one at the moment, hopefully have the carbon on this week

That's more like it!

Never been an issue for me

I could help out if you were in Welly.

The drag washers could just be in the worng order, got a pic?
Normally the antireverse bearing just needs a clean to get it working again, if they get...

That certainly seems like better value

Looks like its just a battery, ac/dc charger, mppt controller and inverter all in a pretty box.

Yeah, would hate to have a wapiti block for 3rd period!

Always had good service from these guys!

I am slowly printing it off chapter by chapter, might look a bit funny dropping 400 pages at once at work!

I'm in Wellington and can check it out if anyone wants?

Deadeye dicks got some, I know that

They are running #4 ultra steel 2 3/4

I have some mates that shoot more ducks than most and they run falcon, will find out what loads they run

On the public land or farms though?
Then I suppose there is the issue of hunting with a shotgun on DOC land

Looking good!

Long for me, but I spend heaps of time bashing through Blackberry and boxthorn etc.

Surely a 257 Robert's would be a better match for a mauser

Pants?

You can still get dies etc easy enough over there too