Thread: 7PRC load data

Originally Posted by 6.5 CRD

I have tried 2217 2225 and RL26 in my 7prc behind 175gr ELDX, hornady
brass and FED215 primer. few things i can note -

RL26 gives the best speed, not by a huge amount though, 2225 wasnt far behind, 2217 was the slowest.

Hornady book max is most certainly book max, theres no sneaking it a little over like you can a lot of other cartridges where the data appears "conservative". Load up something at the hornady book max and you will certainly completely flatten the primer & wreck the brass.

Hornady brass is a bit inconsistent, some of it appears to be softer than the rest. At below book max load (even sometimes just shooting the factory ammo) you will get the odd bit of brass that stamps / hard bolt lift / ends up with a loose primer pocket. Out of 60 cases i have about 45 good cases now after a few reloads and throwing out what appear to be the soft ones.

Thank you. With most of the rifles I reload for, are mostly above book max. I’ll start low and work up. Normally I start mid-high range with load development. Might start at min this time
What speeds were you getting from factory? And what speed did you find the node with 2225?

Cheers for the info about the brass to.