Thread: Gun Porn, show off your new toys

Originally Posted by DavieyJones

Attachment 245437

7mm 375 Ruger. Purchased second hand but pretty sure was built originally by Terminator Products NZ, shoots super nice, came with a Zeiss Conquest Scope which unfortunately doesn't dial as far as i would like to do some long range shooting so in the market for a new scope.

Heck thats my old gun I'm pretty sure. 2013 Greg made that

Sent from my SM-S916B using Tapatalk

Both ladies, dressed in their new frocks for the year. #manners


300NORMA

300Saum

was looking at that thread earlier in the day.

Tikka .308 Swaro Backlanz blah blah blah the part I love the most about it is the cerakote job paired with the laminate stock

Looks great @AdamAnt

Who did the coating? What’s the colour?

Originally Posted by craigc

Looks great @AdamAnt

Who did the coating? What’s the colour?

Close quarters cerakote did it for me
Graphite black with a Tungsten speckle

Currently overseas, but now got this waiting for my return. So I only get to look at the pics and salivate. Hardy 300 PRC, topping it off with a ZEISS Victory V8 4.8-35×60 in some Spuhr mounts. Retirement present…Attachment 246649Attachment 246650

Hopefully I’ve attached a photo this time. (Learner poster)

Had a case for a while, rain day so cut slots with a hot screwdriver, not very well,(stock and barrel without sights) bought a electric soldering gun with hot knife for the tip, did a better job on the scope and upper barrel, but runs too cold and difficult to keep going, might get another foam and try again sometime.
But K95 with 3 barrels and 3 scopes.

Originally Posted by southernman

Had a case for a while, rain day so cut slots with a hot screwdriver, not very well,(stock and barrel without sights) bought a electric soldering gun with hot knife for the tip, did a better job on the scope and upper barrel, but runs too cold and difficult to keep going, might get another foam and try again sometime.
But K95 with 3 barrels and 3 scopes.
Attachment 247334

I use a craft knife fully extended and keep heating that up red hot with a butane torch, cuts through it very cleanly and quickly.

Originally Posted by Mintie

I use a craft knife fully extended and keep heating that up red hot with a butane torch, cuts through it very cleanly and quickly.

I bought a cheap electric carving knife from Briscoes, doesn’t get much easier

Originally Posted by southernman

But K95 with 3 barrels and 3 scopes.
Attachment 247334

Looks well protected, I'd flip the foam and have the wood towards the case spine.
What barrels do you have?

Originally Posted by Norway

Looks well protected, I'd flip the foam and have the wood towards the case spine.
What barrels do you have?

22 Hornet,
5.6x50R
7x65R. In the case.

Originally Posted by southernman

Had a case for a while, rain day so cut slots with a hot screwdriver, not very well,(stock and barrel without sights) bought a electric soldering gun with hot knife for the tip, did a better job on the scope and upper barrel, but runs too cold and difficult to keep going, might get another foam and try again sometime.
But K95 with 3 barrels and 3 scopes.
Attachment 247334

I have found an electric knife does a nice job.

New toy for the inventory
Bergara wilderness b14 in a b&c mountain rifle stock, chambered in 7mm rem mag, Dean Maisy brake, topped with an Element Optics 2-16×50 HDLR.
Fitted a Spartan flush mount last night, just awaiting projectiles to arrive so i can start load development.
Been hankering another rem mag for a whilec