If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed.
Question for you guys out there.
I have a Husqvarna 562XP.
Good saw but I have an issue, it idles ok in the time it takes to position for next ring etc and you are still holding it.
But will not idle for long when you have to move a bit of stuff and place it on the ground.
No problem on big stuff giving it death and cut until you stop it or you run out off fuel.
Any suggestions/tricks to get it to idle for longer/better.
Thanks Owen
Air filter, exhaust gauze too. Check both of them and make sure there's no weird restrictions stopping it breathing.
Welcome to NZ Hunting and Shooting Forums! We see you're new here, or arn't logged in. Create an account, and Login for full access including our FREE BUY and SELL section Register NOW!!
Bookmarks