Thread: rifle change / load/ no bumps etc

Originally Posted by Micky Duck

now here is a suggestion for you...actually for all of you.
when your rifle is sighted in...to your desired ZERO.... put the plurry colimeter/boresighter back on wiggle it around till it settled in place and WRITE DOWN where its now pointing...it doesnt matter a shit if its 3 squares left and 2 up....thats your zero.
in future if you have doubt you slip it on and have a squiz.
you can even swap scopes and retain your zero.....near enough for sub 300yrd close enough anyway...as said earlier,assuming deer had 20" chest...you missed by 10" either way at 300 yards so out by at least 3" at hundy......that will show up like pooh stain on Nanas rug.

you dont need to go to range to check scope is dialing right either...you can watch it do its thing....

Some of us don't use fancy pants super flash harry colimeter contraptions totally unnecessary gear snob kinda kit......we just shoot paper like men did back in the old days sorry MD couldn't resist