Thread: Ruger 10/22 wont cycle

Hi All
12 - 13 inches with supp. on . minus how long is your suppressor ?? hahaa makes a very short barrel !!
you must have a long stock to get it legal length .
i have polished the back of the bolt so that it ramps easier over the hammer . i tried a few other brands of ammo as with most barrels some just work a lot better moa wise than others .. i would go the softer charging spring [ ie cutting a coil off ] rather than modding the bolt to a lighter weight ......
this might cause it to cough cough multi fire . you could polish the chamber as this could be to tight for a semi ..
Good Luck with your improvements

Originally Posted by AR7

Hi All
12 - 13 inches with supp. on . minus how long is your suppressor ?? hahaa makes a very short barrel !!
you must have a long stock to get it legal length .
i have polished the back of the bolt so that it ramps easier over the hammer . i tried a few other brands of ammo as with most barrels some just work a lot better moa wise than others .. i would go the softer charging spring [ ie cutting a coil off ] rather than modding the bolt to a lighter weight ......
this might cause it to cough cough multi fire . you could polish the chamber as this could be to tight for a semi ..
Good Luck with your improvements

Hi, no the barrel is 12-13" which puts it juts over legal, and then the suppressor goes on. sorry if that wasn't clear

Originally Posted by AR7

rather than modding the bolt to a lighter weight ......
this might cause it to cough cough multi fire . s

The firing pin rides "up and over" in a 10/22 bolt, and does need to be struck by the hammer spur. There should be no means of it slam-firing unless you have exceptionally tight headspace or an exceptionally stuck firing-pin, in which case it would do it anyway.